answersLogoWhite
Headlights Tail and Brake Lights
Ford Ranger
Ford Ranger XLT

Why is the anti rear brake light on with a 1P code on on your 1992 Ford Ranger?

8910

Top Answer
User Avatar
Wiki User
2006-08-01 01:22:16
2006-08-01 01:22:16

I had this problem after changing brakes & lines it was becasue there was still air in the lines. Mechanic suggested lifting rear end and oped blled lines for an hour or so to get all the air out of system. Worked fine.

1

Related Questions

User Avatar

check brake light fuse and brake light switch on pedal

User Avatar

The switch is located just above the brake pedal.

User Avatar

For a 1993 Ford Ranger : ( DOT 3 brake fluid )

User Avatar

I have a 1995 ford ranger, and the ABS light comes on when the brake fluid is low. Check and make sure your brake fluid is full. If it is full then it could be a number of different things.

User Avatar

What size is the steel brake line tubing on a 1994 Ford Ranger

User Avatar

The brake light fuse might keep tripping or going out on a 2001 Ford Ranger is there is a short in the line. The fault could also be with the part that tells the brake light to come on. This is located in the steering column. There is a brake light relay switch where the brake pedal is attached to the steering column.

User Avatar

If you mean (brake light) switch, the answer is yes. It is located at the top part of the brake pedal assembley.

User Avatar

where is fuel filter located on a 1992 ford ranger

User Avatar

Under the dash near the brake pedal lever.

User Avatar

Where is the oil pressure sending unit on 1992 ford ranger

User Avatar

What should the thickness be on the front brake lining for ford ranger 2010

User Avatar

To replace the brake light bulb on a 1996 Ford Ranger is very simple. There are four bolts that hold the housing that will need to be removed. After the bolts are removed, the wires connector needs taken off and then the bulb can be twisted out.

User Avatar

Yes , the " BRAKE " light in your dash lights up if the emergency / parking brake is on or if the brake fluid level is LOW in the brake master cylinder in the engine compartment

User Avatar

Take them off and measure the machined surface for width and the diameter.

User Avatar

What is a a/cl dv on a 1992 ford ranger xlt vacuum line

User Avatar

how to change a tie rod on a 1992 ford ranger xlt

User Avatar

Check your brake fluid level in your brake master cylinder in the engine compartment and see if it is down.

User Avatar

For a 1995 Ford Ranger ( in North America ) ( DOT 3 brake fluid meeting Ford specification ESA-M6C25-A )

User Avatar

Brake light fuses location back brake lights

User Avatar

On a 1991 Ford Ranger : Either 9 inch or 10 inch brake drums

User Avatar

here is dome light fuse on 2004 ford ranger

User Avatar

The 1992 Ford Ranger ICM is located on the firewall in the engine compartment. The ICM will be on the drivers side of the firewall.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.