Check engine is an error. You have to go at a garage to see what is the error code, then correct the problem.
You need to connect a OBD-II Scanner to find out.....
It requires a scanner to properly diagnosis a check engine light.
How do you reset check engine light for the 2009 Chevy trail blazer?
Either try disconnecting thebattery for about 10 mins. or have vehicle scanned to determine the problem
Replace your thermostat had same problem it sets a code but no check engine light
Several things could cause the 2001 Impalas check engine light to stay on. Since so many things could be wrong, check the computer codes for any leads on possible problems.
You can either bring it in to a Chevy dealer or use a programmer/tuner to reset the check engine light.
If the check engine light is blinking that means an engine cylinder misfire has been detected
The check engine light (service engine soon) comes on and stays on when a problem is detected by the self diagnosis system of your vehicle.
It means that the engine computer has detected a malfunction that will affect the emissions of the vehicle.
Use an OBD scan tool to reset or disconnect the battery
The check engine light will illuminate.
It requires an engine scanner to do that.
Hi i have an 2001 Chevy impala and my service traction Light is on. plus my safety brake is locked
With engine off. Turn key to on. Press accelerator fully three times. This should reset light.
To reset the Check Engine Light you must go to the trunk of your car get a cro-bar and smash the dash board until the light doesn't come on no more...
No, only a problem that effects emissions will set the check engine light.
A flashing check engine light is an indication of a misfire.
That REQUIRES an ENGINE SCANNER to do that.
The check engine light is triggered by the Engine Control Module (ECM). The ECM receives information from many sensors and determines when to illuminate the check engine light.
ets and check engine light on in 98 Chevy cavalier
There are pages and pages of things that can cause a check engine light. You need to have it checked with a scantool. Then the code can be diagnosed and repaired.
To reset the check engine light unplug the battery for 30 minutes. If the issues still persists the light will still light up when reattached.