0
Why is the coolant coming out the over flow bottle vz commodore?
Wiki User
∙ 8y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you bleed air out of cooling system of a 2000 jetta 2.0 liter?
just add coolant through the over flow bottle slowly until full maybe 2 gallons. then put cap on reservoir and start. check the bottle! if coolant is droping in the bottle you still have air and need to remove the cap and add coolant slowly to force air out. just did thermostat and hoses on 1 today as a matter of fact. Make sure it is G12 coolant as well! special for vw. _doug
Will coolant spill out of the over flow tank if the car is to hot?
put coolant into my over flow car was running hot and the coolant erupted like a volcano on the side of the over flow
How much coolant does a 454 need?
it depends on the size of your radiator. Just fill it with the correct coolant and top off as the thermostat opens. This assumes the engine is cold (sitting overnight) when you start the engine. Run the heater at max while you do this to bleed the system. Once you can no more coolant to the radiator or overflow bottle, cap the system and make sure the over flow bottle is topped up.
Where does the hose from the thermostat housing connect to the engine?
The hose coming from the thermostat housing connects to the upper part of the radiator and allows coolant to flow into the engine...
Where is the radiator cap located on a 1999 Ford Taurus?
The 1999 Ford Taurus does not have a radiator cap. Coolant is added by using the over flow bottle instead of a radiator cap.
After changing the thermostat and water pump on your 1989 Jeep Cherokee it still heats up what could be wrong?
The radiator may be clogged preventing water flow into the engine. With the engine cold, remove the radiator cap. Start the engine and let it warm up to the point where it should open the thermostat. Observe the flow of water in the radiator. If you can't see the water moving, the flow is being impeded somehow. Also suspect the coolant temperature sensor (located next to the thermostat housing).you may have an air pocket in the coolant lines preventing proper flow of the coolant.be sure to flush the system thoroughly to remove any airpockets. There is a bolt on the thermostat housing which you can remove (when cool) that by-passes the thermostat, allowing you to fill coolant. Use a small funnel and fill to top, then replace the bolt. This will allow the coolant in the block to reach water pump, heating thermostat, and circulating the coolant through radiator, etc.Also, remove the overflow bottle, and using a stiff wire (coat hanger in my case) make sure the pipe connecting the bottle to the system is clear. My case I had a calcium-like blockage stopping flow and creating air/steam in system.I just changed the water pump, thermostat, flushed the system. Make sure no air is in the closed presurized coolant system, air in the system stops the water from moving around.Usually the fan clutch deteriates after the water pump went.It could also be that your oil pump is on the way out. Do you have good oil pressure via the pressure gauge? Are any "check engine" lights coming on? Good luck, Badgirl.check the coolant bottle for cracks etc. and also check the pressure capon the bottle. the cap can be no good and appear to be fine. best advice.....go buy a new pressure cap from the dealer and see what happens. i changed almost my whole cooling system before i did the bottle and cap.....nothing got it to run cool until i bought and installed them!!!I, too replaced thermostat, radiator cap, ect, even the cap on the coolant bottle. Finally, I had to replace the plastic bottle itself. Jeep dealer told me they are plastic, and therefore they warp with age.
Why is there no coolant flow into the heater core?
The presence of the valves usually restrict the coolant flow into the heater core.
What do it mean when the radiator boil in to your over flow?
It might be clogged, thus not allowing enough flow It means that the excess coolant is going where it is supposed to. The coolant expands when hot and goes to the over flow reservoir.
If the coolant in an air conditioner has a lower temperature the the air in a building then?
Heat will flow from the coolant to the air The coolant will absorb the heat from the building.
What controls the coolant flow through a radiator?
the thermostat
Does a 95 Dodge Ram have a coolant lift pump for low speed coolant flow?
No. The water pump is the only coolant circulation device.
If the coolant in the an air conditioner has a lower temperature than air in building then?
Heat will flow from the coolant to the air The coolant will absorb the heat from the building.
