Want this question answered?
30 degrees
There are several ways, but probably the easiest way would be to temporarily buck under the afflicted ceiling joist with a 2x6 temporarily, until the joist is in line with the others. Then go into the attic and cut and attach a 2x6 to the joist and vertically to the roof ridge. Remove the buck. The joist should stay in place.
Not knowing if the joist are in need of repair from rot (deterioration) or broken/damaged then replace ment of joist may be necessary. First get a replacement joist of the same or better species and treatment content and dimensions as the existing joist. Then cut the joist to the same length. You may have to cut a small angle on the bottom end of the joist to aid in working it over and between the girts and decking boards. Work the joist within a few inches of the joist to be replaced. Use a short 4x4 to drive the joist or a wood block to strike with a hammer. Take a couple of scrap 2x's and temporarily fasten to the girts and new joist to prevent movement. Then you may try a couple methods to remove the old joist. If the decking is fastened with screws then simply backout the screws. If it is nailed, then a 10 lbs. hammer can often remove most anything you need and is a great stress reliever but I recomend you use a reciprocating saw to cut the fasteners between the joist and decking. Usually the vibration of the saw and nails being cut will loosen the deck side of the fasteners and allow you to go top side and pull the old nail halves out. Once the old joist and fasteners are out you can carefully work the new joist in place. I recommend fastening the old decking to the new joist with properly coated screws or a hotdipped galvanized rink shank nail. Repeat joist replacement as necessary on other joist.
waves
waves
She goes to a Top-Notch Salon and pays $200 for it to be curled and cut...
An indentation cut into a sea cliff at water level by wave action.
Notch can be a noun or a verb. The noun means a place where something has been cut out. Here are some sentences.Head for that notch in the mountain if you don't want to get lost.His cup had a notch where he'd dropped it.The notch in that railing always gives me splinters.Notch can also be a verb meaning to cut a notch. We will notch the arrow so it will fly straight. Gunslingers sometimes notched their gun handles every time they won a fight.
A metal plate, 1.59mm thick and measuring about 76mm x 41mm. Used to protect cable laid in notch in stud.
simply cut it with a knife
Excavations are braced to prevent the cave-in of surrounding unstable soil.
A Wave cut notch is formed when water from low tide and high tides get thrown into the base of a cliff thus weakening it, after time the cliff will break down.Check this site out www.UnderWorldmc.enjin.comThanks!