0
Why is the top of water heater extremely hot hot enough to melt the rubber red and blue bushings around the in out plumbing?
Wiki User
∙ 12y ago
Because heat rises - the top of the water heater will always be hotter than the bottom.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
can plumbing go through joists?
Yes. It isn't desirable but can be done. However you need to understand enough about construction to know how to do it properly without causing damage to the joists and areas around them.
What did plumbers used for pipes used less today?
Plumbing gets its name from the Latin plumbum, the word for lead.Lead was used for centuries in plumbing as it was soft enough to be easily worked. However, it is a toxin and it was found that some traces of lead were getting into the water passing through the pipes - and was accumulating in people's bodies.
Why is the spindle on the lathe hollow?
The hollow spindle of a lathe allows for longer lengths of material to be held in the chuck thus eliminating constant material changing to and from the lathe in production turning. The best advantage is the saving in material costs. If one had to manufacture 20 bushings and they were all cut into separate billets, half of the material would be lost because the chuck needs some material to grip the work piece on. If for example 20 bushings of 50mm OD by 50mm long have to be made, one would need a piece of material of at least 1150mm long. A single shaft or hollow bar of this length can usually be stuck into the hollow spindle with only enough material sticking out to make one or two bushings at a time. Once they are parted off, the material can simply be pulled out and the next one or two bushings can be machined. In the end the wastage will only be a piece of material of 70mm long instead of 20 pieces of 40 or 50mm long without a hollow spindle.
How is the best way to unclog the main drain under a house?
Use a acid strong enough to burn through dirt but not strong enough to burn through metal adicdasy level should be around 1.5.
Winding a wire in loops around an iron bar creates an?
It creates an iron bar with wire coiled around it. It can also create a spring, provided it stays in the same place for long enough so that it holds it's shape.
Is foam polyurethane toxic to those who are around it?
It is slightly toxic, but not enough to be banned or not to buy. Just be careful around a flame though, it's extremely flammable.
can plumbing go through joists?
Yes. It isn't desirable but can be done. However you need to understand enough about construction to know how to do it properly without causing damage to the joists and areas around them.
Your one breast is extremely itchy - morning noon and night - around the nipple and inside the nipple - its enough to drive you crazy?
sexy question
On a Chevy s10 how do you reinstall the two bushings that go on the Allen bolts and sit between the caliper and the rotor cause there's not enough space?
You should note that the bushings fit into the holes in the caliper. So there really is enough room there. Put the bushings in the holes and fit the caliper over the rotor and work it back into place by jiggling it back and forth and down onto it. Then put the two Allen head bolts back in when the bolt holes line up.AnswerRemove caliper? From the rear?
how plumbing works in a home?
The plumbing system in your home is composed of two separate subsystems. One subsystem brings freshwater in, and the other takes wastewater out. The water that comes into your home is under pressure. It enters your home under enough pressure to allow it to travel upstairs, around corners or wherever else it's needed.
Why does your toilet get cloged when you take poops?
there is an obstruction in the plumbing...
What are the typical parts of pool plumbing and identify their purposes?
Not enough room in this format to elaborate. Go to a pool store for that info.
Why does the front end squeak on a 1997 Ford truck?
If the bushings wear enough (usually are 95% of the squeaking problems) the front wheel alignment can change and can wear the tires faster if not make the vehicle pull to one side of or the other. There are rubber bushings on the bolts that attatch to the frame that keeps some of the vibration and noise down. They can dry out or harden and can either fall out or twist enough to wear metal to metal.
Can candy spoil?
candy can spoil because if you flush the toilet to many times then the plumbing will screw up your candy or spoil it because plumbing is like when there is a bad strom comes we get sore plumbing is like that to candy and it spoils it bad enough to cause a bad illness called candieflatritousgagphlapiotis.
Does using a hula hoop burn many calories?
if you do it fast enough and long enough it is extremely efficient
Is aqueous NH4Br acidic?
Extremely! Enough to burn your skin off...
What certifications does a Huntington Beach plumber need to work in Wichita, Kansas?
Plumbing Certification is enough for a huntington beach plumber to work in wichita
