use an ohm meter goin in to the coil (my wire was green w/ orange stripe) if nothin run hot wire from batt to that wire if it works thers a short comin out of the relay box i rigged mine ask a pro for the right way good luck
The crank sensor is on the top driver side of the bell housing.
probably crank sensor, they are famous for that
The ignition module uses the crank sensor to decide when to spark.
You can not. The crankshaft position sensor is required to run the engine.
In the underside on the far left
driver side on the back of the motor where is crak sensor on 94 jeep 4.0 grand Cherokee
Usually a crankshaft sensor is located on the bellhousing of the transmission
in a toilet
It has both.It has both.
most likely is your crank position sensor. located on the bell housing.
Yes. The Crank sensor monitors the position and rotational speed of the engine to determine timing for ignition. if it is not functioning you will get no spark.
It should be on or near the throttle body.