Not enough oil was added.
i had same problem. the tubing the dipstick slides into, is two pieces that slip into eachonther. loosen up braket that's holding dipstick then adjust tubing. retighten bracket. this drove me nuts one day...
Where it indicates "full" on the oil dipstick. Overfilling will cause too much pressure and possibly rupture oil lines.
Remove the oil fill cap which has a built-in dipstick. Wipe the dipstick with a clean rag. Stand the bike straight up in the riding position (not on the kickstand), replace the dipstick and remove it again. Check the level and color of the oil on the dipstick. * Note: When replacing and removing the dipstick, try not to shake the bike around as this will give a false reading.
Use dipstick as a guide. Fill to proper level when engine off after it has settled/drained back to the pan.
The 3.0 Jaguar engine holds between 4.5 and 5 quarts during an oil change. Add a little less, then keep adding to fill depending on the dipstick reading.
no
Add 2 quarts of Honda 4stroke motor oil then check the level @ dipstick and adjust accordingly. Good luck & don't forget to change the oil filter.
I am not expert but on the Sequioa, there isn't a dipstick because they use a special tranny oil that you don't change. It is a sealed system that you only change if you notice slippage. Called WS oil.
Pull over and park when it is safe to do so. Turn engine off. If you are not a mechanic call for help. Otherwise open the hood, wait a couple minutes, pull engine oil dipstick. Take notice of engine oil level reading on dipstick. If the dipstick reading shows nothing, do not drive any further until you can add oil. If the dipstick shows you have oil, you may want to have your car towed home. If you continue to drive the vehicle with the low oil pressure light on you may destroy the engine.
you will either have a hatch mark or a hole drilled in the dipstick if you have the hatch mark then at the bottom of the mark if a hole then the bottom hole
check you oil level on the dipstick. add some or get an oil change.
You can change the fluid with a mity vac from the dipstick and replace with SPIII fluid -