0
Check the switch. It has a different one than the regular brake lights. the light bulb could possibly be blown
Wiki User
∙ 19y ago
Add your answer:
Earn +20 pts
Why does the third brake light work but not the others?
There could be a separate fuse for the lower brake lights , or maybe both lower brake light bulbs are burned out
Why dos therd brake work and not the others.?
depending on the vehicle - some have a separate fuse for the third brake light
Where is the fuse for the third brake light on a 2001 F-150?
the third brake light is direct from brake light switch no fuse
How do you change the center third brake light on a 2003 E320?
Begin by removing the wiring harness from your third brake light. Remove the third brake light retaining screws. Reverse the process to install your new third brake light.
Ford explorer sport trac third brake light works but others dont work?
I have the same problem - but my third brake light slightly flashes when the car is of (Explorer 1998). I have replaced the "stop light" switch with no improvement at all.
Third brake light on a 96 Chevy beretta?
how to change third or center brake light on Chevy beretta 95
How do you replace third brake light in 2009 Hyundai sonata?
How to change third brake light in 2009 Hyundai sonata
How do you replace the third brake light on a 2005 Buick lacrosse?
How do you replace the third rear brake light in a 2005 buick allure
Who was the third rear brake light named for?
The third brake light is named for then Secretary of Transportation Elizabeth Dole and are called "dole lights".
What year did Chevelle introduce the third brake light?
Chevelles never had a third brake light since the Chevelle name was dropped after 1977. However, third brake lights were first installed (and required) in 1986.
Wire a third brake light on a hot rod?
you have to pull the feed wire off the brake switch to supply power to the new third brake light. get a test light and test the wires on the brake switch....one is hot all the time the other one gets hot when you depress the pedal....that is the one you need. do not take it pull your power from the rear light it might have an intergrated turn signal wire. which would make your 3rd brake light blink.. ok.have fun! you have to pull the feed wire off the brake switch to supply power to the new third brake light. get a test light and test the wires on the brake switch....one is hot all the time the other one gets hot when you depress the pedal....that is the one you need. do not take it pull your power from the rear light it might have an intergrated turn signal wire. which would make your 3rd brake light blink.. ok.have fun!
How do you remove a third brake light?
with a hammer
