They will often use 95% oxygen and 5% carbon dioxide for victims of CO poisoning because they are trying to force the CO off the hemoglobin on the Red Blood Cell.
Not really. Carbon monoxide fumes are toxic and it is cheaper and easier to produce (and use) carbon dioxide instead. Additionally, carbon monoxide is flammable. It reacts with oxygen to form carbon dioxide.
There is not enough oxygen for the paraffin to burn fully, producing poisonous carbon monoxide instead of non-toxic carbon dioxide.
When you burn something without enough oxygen for complete burning, you get incomplete burning; for example, instead of getting carbon dioxide as a combustion product, you could get carbon monoxide.
water, carbon monoxide, and charcoal will generally be produced. if the fuel being burned is a hydrocarbon base material.Related Information:This form of carbon (charcoal) is produced by the heat generated from the combustion, but lacking sufficient oxygen, doesn't oxidize further.When there is sufficient oxygen available, usually charcoal is still produced, but further oxidized to carbon dioxide.
neither diffusion nnor perfusion limited
It depends. It sounds like you're burning something, but you don't say what. If it's a hydrocarbon (such as methane, CH4) then it normally produces carbon dioxide (CO2) and water (H2O). However, if oxygen is in shorter supply then you could end up with carbon monoxide (CO) instead of carbon dioxide.
Propane combines with oxygen (in the air) to form water and carbon dioxide. When not enough oxygen is available, carbon monoxide (or even soot, raw carbon) is formed instead of carbon dioxide.
CO or Carbon Monoxide.
Carboxyhemoglobin (COHb)-- Hemoglobin that is bound to carbon monoxide instead of oxygen.
C2H5OH + 3O2 → 2CO2 + 3H2Oethanol + oxygen → carbon dioxide + waterThis is the equation for complete combustion of ethanol in air. If there is a lack of oxygen, carbon monoxide (CO) may be formed instead of carbon dioxide (CO2). Further deprivation of oxygen will lead to unburned carbon residue (C), or soot.
The complete combustion of a hydrocarbon would give carbon dioxide and water as the only products.
Carbon Dioxide iswidely used for MIG welding but I never heard of carbon monoxide and it is definitely not used in the industry as shielding gas. The purpose of the shielding gas is not just shielding the weld pool but offer arc stability with an adequate ionization potential. The heat and electrical conducctivity of the gas at the arc temperature are a huge factor as well.