Ford Explorer
Ford Explorer Eddie Bauer
Ford Explorer XLT

Why will a 97 ford explorer will not stay running the motor is a v6 4.0?

123

Top Answer
User Avatar
Wiki User
2011-09-13 17:05:36
2011-09-13 17:05:36

have you tried to change the alternator ? just a suggestion

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

I believe that is a defective daytime running lamp (DRL) module

User Avatar

why does the dome lights stay on when the switch is turened off 2001 ford explorer super

User Avatar

What I did was find the correct fuse for for the ABS motor and remove the fuse . the abs light will stay on but this did it for me. or find the motor just in front of the master cylinder and unplug it.

User Avatar

The 1991 Ford Explorer should have a separate starter relay that sends power to the starter. It sounds like the relay has stuck and is sending power to the starter even after the vehicle is running.

User Avatar

ran my 95 ford explorerout of gas and i replaced the fuel filter but she doesnt want o start and then when it does it doesn't want to stay running without reving and it still bogs down

User Avatar

Bring to a shop that has an ABS scanner to determine the problem

User Avatar

1987 Ford F350 want stay running

User Avatar

You can turn off the seatbelt warning light in your 2006 Ford Explorer, by buckling the seatbelts. When the seat is occupied the warning light will stay on until the seatbelt is buckled.

User Avatar

Something is wrong with the charging system. Defective alternator would be my guess.

User Avatar

have a pontiac 6000 2.5 motor and it wont stay running

User Avatar

If you are referring to the daytime running lamps (DRL) on Canadian Explorers not turning off when the parking brake is engaged, I believe that is a defective DRL module.

User Avatar

A Ford 1999 Expedition engine is probably not seized if it will start and idle but will then not stay running. This could be due to a clogged fuel system, faulty injectors, faulty spark plugs or a wiring problem, or even a faulty distributor.

User Avatar

Type your answer here... It could possibly be the ignition switch.

User Avatar

If the lights in your lock buttons remain on after the truck is powered off, you may have a problem with your fuse. It the light remaining on could be because you have an electrical problem in your Ford Explorer, as well.

User Avatar

Yes , the socket is live so you can use the cigarette lighter without starting the Explorer or turning the ignition key to the accessory position

User Avatar

check brake light switch on brake pedal maybe getting bad

User Avatar

Check the PCV Valve in the front half way down the engine

User Avatar

check the brake light switch. located on the brake pedal it may be bad

User Avatar

No, a three phase motor will not start if one leg of the motor feeder is open. The motor will stay running once the motor looses a leg butnot for long if the proper motor protection is provided. The motor protection will sense theline failure and disconnect the motor from the voltage source.

User Avatar

Can it make the vehicle kill or not stay running what does it actually do.

User Avatar

loss of voltage is caused by;loose fan beltbad alternatorbad voltage regulatorloose battery connections


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.