answersLogoWhite

0

Because its designed to operate at 230-460, not 120-208.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Which motor would have higher current flow 2 ohms motor in a 6 volt circuit or a 3 ohm momtor in a 12 volt circuit?

expecto patronum! ~:)


Can a integrated circuit chip of nine volt supply used with 12 volt motor and work properly while using with bettaryof 12 volt?

no


How many amp circuit breaker for 3 hp 230 volt motor?

16A


How do you connect a volt to a circuit?

A volt can not be connected to a circuit.


How do you power a 3 volt DC motor with a 12 volt battery?

you would have to put some type of resistor in the circuit with the motor...the resistor would have to be in series with the motor and would have to be of a high enough value to lower the voltage by 9 volts....There is a formula for working this out but you would need the amperage of the motor to figure this....


Can you connect 460Vac motor to 480Vac circuit?

Yes, the 440 volt motor is withing the 10% voltage range of the 460 volt group. When the supply is said to be 480 volts, usually it is lower than what it is stated to be. Once the motor is connected check the current against the motor's nameplate amperage.


Is 24 voltage a lot?

It depends on the use it is being put to. It is sufficient for a 24 volt circuit. Too much for a 12 volt circuit and too little for a 240 volt circuit.


Is a map of a circuit a volt?

A map of a circuit is not a volt. A map of a circuit is referred to as a schematics chart. The schematics chart details the path of the circuit, from beginning to end.


Acceptable voltage drop for 3 phase 415 volt motor?

The voltage drop should not exceed 3% on a feeder or branch circuit.


Can you use a 6 volt relay to 230 volt circuit?

If you are talking about a 6 volt coil, yes, so long as the contacts are rated for the 230 volt circuit. If you are talking about 6 volt contacts, no, absolutely not.


Can you use a 3 volt battery to run an 8 volt motor?

You can but the motor may not run, however you will not burn the motor.


Can a put a Receiver from a lower Volt motor to a Higher Volt motor so i can control it with the transmitter i have?

NO