First step is to open you hood and disconnect the negative battery terminal. Under the hood, on the firewall just below the motor wiper there is a square box that contains the module for the wiper's speed and delays. In the front of the box locate the bolts that hold the cover (usually are hexagonal), Remove the plug connection on side, then remove the circuit board, it just comes out. Visually inspect the board for cracked or loose connection or solderings, Some fissures or cracks may be not visible at all as they are under the soldered points. Clean the entire board with electronic spray cleaner (can be bought at any automotive store). With fine point soldering iron go over every terminal just touching them very briefly, you will be able to see the quick remelting of the soldering, do it with patience and plenty of good light, be careful not to touch plastic parts and wait until your soldering gun is hot. After you have gone over all the points you were able to touch, get a fine sand paper (the black kind) and sand gently the contacts on the two spring like contacts, try not to bend them (the contacts may be at different levels, that is normal). Replace Board very carefully it must go without putting pressure as putting excessive pressure may crack it. Replace connection and cover and tighten it gently. Connect battery. Start and test it, it should be working fine again.
The 1993 Ford F1 50 windshield wipers to stop working. The fuse can be found in the fuse box. The location of the fuse is listed on the inside cover of the fuse box.
This is a bad question. fix it. check fuses . there are sevearal fuses that will stop it from starting
because there not supposed to idiot
check the #18 fuse for the injector in the engine bay. My 2001 venture blows that fuse when the wipers are activated. Im in process of finding the problem.
A bad relay switch will cause the windshield wipers to not turn off. Replace the relay switch and the windshield wipers should turn off.
i put a new windshield wiper moter in and the fuses are fine but my wipers still wont work
check ground on wiper motor
possible faulty relay
It's probably the mechanism that connects to the wiper motor. You may need to pull the cover to see what's loose or damaged. It's probably not much of an expense and the most difficult part will be aligning the wipers after you've identified and replaced the faulty parts.
my suburban wont start
Check the fuse and the relay.
Because your model is gone, as are most models on Sorento. You can stop that problem once and for all (along with the fantastic light problems) with a new dynamo with an overpower filter. (Bosch is a good solution)