0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Why 81 thunderbird won't restart after shutting it off?
could be that the coil is getting hot and wont restart until it cools down.
2003 Chevy 2500 goes dead and will not restart until it cools down?
maybe your fuel pump or a massive air flow sensor
Why does a 1990 ford escort 1.6 not restart afterdrivingfor 20 mins until it cools down Replaced battery and starting motor?
sounds like your fuel pump is gettin hot
My engine stopped on my 2002 PT Cruiser after my radiator went out I tried to restart and it still would not do anything. Is this normal?
It may restart when it cools down or you have toasted your engine. Where is your common sence. Stop next time that happens.
What could cause an electrical circuit to go dead and several hours later restart?
Electrical circuit do not go dead but theyreliably shut down. If there is a thermal protection circuit supervising the heat dissipated that would the circuit to shut down until it cools and start again and probably repeat the cycle.
What would cause a 97 dodge stratus to shut down while driving and not restart will crank but not start?
fuel pump?
Will a bad ingition control module cause a car to die while driving?
It would die and not restart. Yes it may restart! I have had modules quit when they get hot and work again when they cooled down.
What nutrient cools us down?
Water in your sweat cools you down.
Why would my 2003 KIA RIO stop running while driving down freeway and not restart?
Possibly, you have a broken timing belt.
Why does your 86 Honda CT 110 conk out after 4 miles and wont restart till it cools off?
because it is an trial bike and these bikes need to be cool down after a long distance.
Why would battery and starter cables get so hot that you cant touch or restart until cools down on a 1974 F-100 PU with a 390 motor?
either your battery does not have adequate cranking amps or your starter motor needs overhauling if new battery, i would pull starter and replace
According to the warning in your lesson you should not work on manifold connections and fitting until?
the water heater cools down.
