0
Why wont my Ford f150 1986 that doesnt start i changed timi ng chain magnetic module spark plugs wiring?
Wiki User
∙ 14y ago
You need compression, fuel and spark. You are missing one of those.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What is the wiring diagram for a 1976 f-250 from ignition module to distributor and from module to key source?
Here is the wiring diagram:
What is The Wiring position for the ignition module on a 1990 Buick park avenue?
what is the wiring position for the ignition module on a 1990 Buick Park Avenue?
What can you do if the right brake light doesnt turn on or the right turn signal. I've changed the bulb twice already it's only the right.What do you recommend?
wiring.
What is the meaning of sink source in PLC?
Sink - A wiring arrangement in which the I/O device provides current to the I/O module Source - A wiring arrangement in which the I/O module provides current to the I/O device
How do you disconnect an aftermarket car alarm on a 2001 Chevy Camaro?
be carefull, removing the aftermarket module can make the car not start, as they may have tapped into the ignition circuit.... check all the WIRING going to their alarm module, and see if they have changed any of the original harness... good luck :)
Wiring order for a 1991 Pontiac SunBird ignition module?
what is the color order of the wires to a Pontiac Sunbird ignition module
How do i change the ignition module in a 1998 suburban?
Begin by removing the wiring harness from your 1998 Chevrolet Suburban ignition module. Remove the ignition module retaining screws. Reverse the process to install your new ignition module.
1998 Buick Regal Gs Rear driver side brake light does not go on when you apply the break why?
more than likelly your bulb has burned out and needs to be changed if that doesnt work could be in the wiring
Where is the engine control module on 89 ford f-150 302?
wiring diagram
Is the 2008 avalanche trailer brake controller wiring the same as a 2005 avalanche wiring?
No it is not. They changed the wiring in 2007, it is no longer "plug and play".
Is T8 and T12 fixtures same wiring configure?
The T8 tubes are usually associated to fixtures with electronic ballasts whereas T12 tubes are used in magnetic ballasts. The tubes can not be transposed because the socket wiring is different. If you are converting a magnetic ballast to an electronic ballast the wiring diagram is on the label of the ballast.
Where can you find the wiring diagram of the Lucas ignition module in a 1990 Laser 1600?
haines manual
