Begin by removing the wiring harness from your 1998 Chevrolet Suburban ignition module. Remove the ignition module retaining screws. Reverse the process to install your new ignition module.
Here is the wiring diagram:
what is the color order of the wires to a Pontiac Sunbird ignition module
Remove the ignition module retaining ring. Pull the ignition barrel out. Remove the wiring harness from the back of the ignition barrel. Reverse the process to install the new ignition module.
Remove the wiring harness from your 1995 Chevy Blazer ignition control module. Remove the ignition control module retaining screws. Reverse the process to install your new ignition control module.
There is no ignition module on a 1987 5th ave. The spark control computer is on the air cleaner with a vacuum line hooked to it.
Probally the crank shaft position sensorid replace that first next would check ignition module under ciolpack
The ignition module uses the crank sensor to decide when to spark.
it is located on the side of the air cleaners housing the one that say ignition control module in all chryslers car
the ignition module is in front of the lft front wheel,inside the fender. the module wiring harness runs thrue a hole /gromet in the fender into the engine compartment just in front of te ignition coil.
The electronic ignition control module on an automobile is installed by first locating the unit at the top of the engine. The wiring harness is then disconnected from the original unit an a new module put in its place.
haines manual