your on off switch may be bad, get it checked.
my cruise control light will blink on an off and the care will move.when it is not blinking the truck will not move, why is that
To the left of the steering wheel, below the dashboard is a button that says cruise control. Push that button in, the dash will illuminate the cruise control light. Then, as you reach the speed you want to cruise at, push the button on the steering wheel that says "set". When you want to turn cruise control off, simply tap the brake pedal and the cruise will go off.
2001 Equipped Buick Lesabres have two different cruise control activation switches. The first turn the cruise control ON. The switch sets which speed the throttle will be locked at. This problem can be caused by the primary sources, the system is being operated manually or switch and or cruise control module failure.
On the lower left side of the dashboard is a switch to turn on the cruise control. Depress the switch downward to activate. Once activated, set the speed on the steering wheel speed control.
To use the cruise control on the PT Cruiser, turn the cruise control on in the steering wheel. Accelerate to the desired speed and push in the end of the left turn signal knob. The cruise control should then control the speed. To take the car out of cruise control, a person can tap the brake.
This sounds like a direct short my 2001 frontier does that too, i was told it was an electrical malfunction.
This light means that cruise control is on. Turn it off by sliding the switch on the left stalk in the way
The fog lights are controlled by a separate button next to the cruise control and sun roof. If the indicator light is on, the fog lights will be activated with the headlight switch.
Cruise "light" gets power through "Meter" (10A) fuse. Cruise control combination switch is wired to "Turn" (10A) fuse. Both fuses are in passenger compartment fuse box (under lid next to driver's left knee).
1) turn on cruise control (a light should turn on somewhere) 2) increase or decrease speed to desired mph 3) press button or apparatus to set or reset cruise 4) take foot off gas peddel and the car should maintain steady speed. I've had 2 VW's and the cruise didn't work in either one....perhaps your cruise just doesn't work.
check the fuse
You can turn the traction control on and off. If the light is on, then it is turned off or there is a problem. Read your owner's manual.