0
If the water is mooving through the filter and there is no pump preasure it could indicate that your filter has a hole or tear in it if you have a cartridge filter.
By no pump pressure I assume that you mean the water is not moving in the pool. A number of things can cause this.
1. A clog in the Plumbing
2. A blockage in the pumps impeller
3. Excess debris in the hair and lint strainer
4. An improperly closed valve forward of the pump
5. Low water level. You will usually experience excessive air in the returns or a surging into the skimmer along with a gurgling sound.
6. A dirty filter
7. A crack in the pump housing
Wiki User
∙ 13y ago
Wiki User
∙ 14y agoyou have an air leak, pump lid can be loose, cracked or the o-ring needs to be replaced. The valve in front of the pump may need serviced or if it is a Jandy 3 way that has a grease fitting, it may have broken off or needs to be lubed. Do you have a pool cleaner that works off of suction, if so check for holes for cracks in the hose. The Skimmer has weir that might be stuck in the up position or closed position. The water may be to low and the skimmer is "starving for water" fill the pool until it is half way up the skimmer opening.
Wiki User
∙ 13y agoIs the power turned on, is the timer turned on. is the motor in good order.
Make sure you have power at the system. If you have another pump like a cleaner see if it will turn on. If it does then you will need to have an tech or electrician come out and test for power going to the motor. Your clock may be bad, motor capacitor on motor could have gone out, wiring to the motor may have a short.
Wiki User
∙ 14y agowhy is there a purple line around the top water line in my pool
Wiki User
∙ 14y agoMight be clogged, have an animal stuck in it. Try to get that checked out.
Wiki User
∙ 16y agoIt wasn't put together properly
Wiki User
∙ 10y agoyes
Add your answer:
Earn +20 pts
The water pump in a foxxx pool is not pumping water into your filter It is running what other reason could cause this?
if the motor is running but there is not pumping water; # It may need to be primed, that is there is no water around the impeller and as a result is not pumping. to get it going if that is the problem fill the pump with water if possible and make sure there is no blockage on the pool side, then start the pump sometimes it helps to turn the pump on and of while the air is being expelled. # On the other hand the impeller may be damaged blocked or no longer properly connected to the motor if there is no movement in the water at all that is probably the problem.
What is the difference between filter and recirculate on a pool pump?
First of I think you may be referring to the pool filter not the pump. "Filter" runs the water thru the filter thus filtering the water. Recirculate, I believe, bypasses the filter media and sends the water back to the pool unfiltered. K
Bubble in above ground pool pump?
Don't worry about it unless it interferes with the pumping of the water.
Do you need a pump and filter for your 10 X 30 pool that holds 1000 gallons of water?
I have a 10 x 30 pool but i don't seem to need a pump and filter!
Will it damage the pool pump or filter to let the water level drop?
So long as there is water coming through the pump when it is running it doesnt matter what the water level in the pool is.
Are there sensors on ignition which causes the fuel filter to start pumping?
No, the filter can not pump. It is a filter.
Should an ingound pool filter be run at the same time as a pool heater or can you just run the heater alone?
Heaters are usually plumbed in after the filter. The pool filter/pump is what circulates the heated water. Ans: The heater will not work or fire if the pump is not running.
Is a pool heat pump a pump also or does it require a pump?
A heat pump's name is a bit deceiving, it's just an appliance that heats water. You still need a normal pump and filter combination to move and filter the water.
Your pool pump is working but it is not pumping water from the pool its like there is a blockage some where what could be the problem?
could be , is the water level above the skimmer/s / are the skimmer baskets clean/? pump may have just lost it's prime. fill pump with water replace lid and restart.
Do you leave filter pump on while shocking your pool or?
Yes, you should run the pump when you add chemicals to your water,
What size pump do you recommend for pumping water off the top of the pool cover before you open your pool in the spring?
Any small submersible pump should do the job. just be careful that it doesn't suction onto the pool cover while it is operating.
Fuel pump is pumping but not getting fuel?
even though it sounds like it is pumping it may not be, try a new pump and new fuel filter
