Sounds like the crank position sensor is faulty. Get a volt meter, set it to AC.Find the crank sensor on the block of the engine. Disconnect sensor and probe the two wires with the meter. Crank engine and you should have 0.2 - 2.0 volts ac. If this is not the case replace. If ok, carry out same check with camshaft sensor on top of engine. Hope this helps.
"Check Engine" light comes on when you turn ignition switch on and should go off when engine cranks.
If the check engine light is or has illuminated, check for codes.
It means that your relay is out, and has to be replaced with a new one, and once its been replaced, your check engine light will turn off in about 20 minutes or so.
I had all sensors replaced in my 03 Trailblazer and the check engine light stiil comes on. Why?
A clogged or defective fuel filter will very likely cause a check engine light. If it is suspected, it should be replaced.
check engine light reset on a 1999 Acura CL 3.0.. Just replaced the egr valve. Thx
Disconnect the battery for about 10-15 minutes resets the computer, and that means no Check Engine Light after you have fixed/ replaced what was wrong.
Is there a reset button on a 1996 rav4? Had it checked out, and said it need spark plugs and wires. Replaced it and check engine light still on.
your Alternator
The head lights have nothing to do with the check engine light.
I replaced a broken Gas Cap 2 weeks ago and the Check Engine Light came on 1 week ago. I got the code P4055 today - and am hoping that the New Gas Cap will fix the problem. How can I reset the Check Engine Light?
i have a 1994 eclipse with a 1.8 we replaced the head gasket and timeing belt now it sputters at low rpms an the check engine light is on what could be th problem ?