Brake light switch stuck or out of adjustment. It is either located on the brake pedal somewhere or it may be a pressure switch located on or near the master cylinder.
Check the petal and make sure that the plastic part that touches the brake light switch when the petal is in contact with the brake light switch is still on the petal, if it is missing you will need to replace it, so the petal will make correct contact with the brake light switch.
check the fuse for the brake lights, they have thier own. also check the brake light switch at the at the top of the brake petal
Only if the bulb or wire is burnt out... Else the switch has defect,,
abs codes are retreved by juming obd2 terminal 4-12 after codes plump brake petal 6 times
Check to see if your brake lights work. If not, there is a switch attached to your brake petal Assembly that probably came loose. plug it back in and it should work....
Blinkers can work without brake lights. Brake lights are activated by a switch that is switched by the brake petal and the turn signals are acivated by your turn signal switch on your steering column. The two are two separate circuits. I suggest you check out the switch on your brake pedal to see if it is working properly. It must have 12 volts applied to one side when it is not acitvated and 12 volts should be on both sides when it is activated. When the 12 volts is on both sides of the brake switch, it should apply 12 volts to your brake lights and then they should come on.
Air in the brake lines
you dont you bleed and adjust the brakes
Your brand pads are worn out. Stop driving this car until you can have the pads replaced.
Your brand pads are worn out. Stop driving this car until you can have the pads replaced.
i have a 72 nova and the left turn signal blinks faster than the right what is my problem
The Brake booster needs replaced