0
Why would the battery come on but the engine not crank over on a 1994 Buick Park Avenue?
Wiki User
∙ 16y ago
you have two systems that turn over a motor it could be your battery but it sounds like the starter or something in that system like the silinoid or starter relay or it could be just a loose or damaged wire.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
How do you change the crank shaft on a 1995 Buick Park Avenue?
By disassembling the engine. Not a DIY job.
What would cause a 1991 Buick Park Avenue not to start when the engine is cold?
check crank sensor
1992 Buick road master after you put a new battery it crank but wont start what is the problem?
1992 buick road master after you put a new battery it crank but wont start what is the problem
Where is the crankshaft sensor located on a 2000 buick park avenue?
Behind the crank pulley that your belt rides on!
Where is the crank sensor located on a 1991 Buick Park Avenue?
It's just behind the harmonic balancer.
1993 Buick park avenue will not start?
my 1993 buick park avenue wont start after i changed the front motor support you can jump it from the sodinoid and it will crank whats wrong could it be the security system
How do you tell if engine is locked up on a Buick Roadmaster?
It won't crank!
1985 buick park avenue died at stop sign?
Also engine turn but has a muffled sound when trying to crank. I was diving car home and car just died and would not start back up.
Where is the cam sensor located on a 1992 Buick Park Avenue 3.8L?
IS CALL CAMSHAFT SENSOR AND IS LOCATED ON THE RIGTH SIDE OF THE ENGINE , ABOVE THE CRANK PULLEY You will have a crank sensor, but it won't have a cam sensor. it dose have a cam sensor, on the timing cover left sind of water pump
Can I drive the car a 2008 Buick 6 cylinder with a faulty crank sensor?
No. The engine won't run with a faulty crank sensor.
Where is the crank shaft sensor on a 1994 buick lesabre?
under the crank pulley, right side of car under front of engine
How many volts does it take to start a buick?
The normal battery voltage is about 12.6 volts with no load. Anything much less than this indicates the battery is not fully charged or is degraded. The key to starting an engine though is what does this value drop to when you start to crank the engine. If the battery is weak and the engine does not crank, the voltage could drop below 10 volts. If your car has a voltmeter in the instrument panel, note the value without cranking and then when you do crank to see how much it changes. Two six volt dry cells will produce 12 volts, but wont start a car.
