0
Alternator may not be charging battery sufficiently- check with a voltmeter A fully charged battery should read approx. 12.8 volts without engine running With engine running should read approx. 13.8-14.2 volts
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
How do you bypass the battery light in dash to complete charging system on a 1984 BMW 318i?
Why in the world would you want to do that? The light is there to warn you there is a problem with the charging system. If it is on, there is a reason. But if you insist, just pull the bulb out.
Who to Change engine check light bulbs on a 1996 BMW 318i?
Who to Change engine check light bulbs on a 1996 BMW 318i?
Where is the clutch reservoir in a 1984 BMW 318i?
The brake fluid and clutch reservoir are one and the same on the 1984 model.
How much horsepower does a 1984 BMW 318i have?
The 1984 BMW 318i has approximately 101HP as the lowest value. This number is from the Wiki page for BMW 3 series located at http://en.wikipedia.org/wiki/BMW_3_Series and the exact statement is for each market is as follows: 1984-1985 318i - 1.8 L M10B18 I4, 101 hp (75 kW) - North America 1982-1987 318i - 1.8 L M10B18 I4, 105 hp (77 kW) - Europe Good luck and take care. Noisome
How to reset oil service light manually 1996 bmw 318i?
To reset the oil service light manually on a 1996 BMW 318i, disconnect the battery. Leave it unhooked for 10 to 20 minutes.
Why did your battery light come on a 1995 BMW 318i?
Your battery is probably dying
What is the red light on a BMW 318i with a circle and dotted lines around it?
Break discs man!!
How do you reset an abs light on 1997 BMW 540i?
how do I reset tne brake pad sensor light on a 1997 BMW 318i
Where is the temperature sensor 318i?
where is the temperature sensor 1993 BMW 318i
What are the differences between the BMW 318i SE and the 318i M Sport?
was the difference between 318 se and a 318i sport 2001 2003
Oil light stays on BMW 318i?
It's oil level or pressure. If level ok, pressure test.
How do you reset the oil light for a 1996 BMW 318i?
you need a factory scanner ,remove the bulb ,much easier
