I believe the hazard flasher switch is in the instrument panel by the radio
location of hazard flashers on 93 saturnsc2
Double check the wiring diagrams for your vehicle but it's probable the flashers and signals use the same relay to function. The wiring for your flashers will go through the hazard switch which is where the malfunction is. If you replace the switch your problem should be solved.
check the flasher itself and the switch
If your referring to the emergency flashers.... it'snactually in the turn signal switch. i have a 94 mercury cougar xr7 and when i bought it the emergency flashers did not work. i in the end i had to replace the entire turn signal switch in the steering column.
It sounds like the switch for your emergency flashers.
Often, a separate flasher unit is used to activate the hazard flashers. This unit might be bad, or the switch to activate the hazard flashers might be bad. answer always there are 2 flashers.one for turn signals other for hazard replace hazard flasher They have separate fuses also.
Not sure what vehicle you have but with most vehicles the signals and emergency flashers are separate circuits. Each have there own fuse and flasher. Check fuses, bulbs and flashers. If all checks okay it may be the signal switch at fault.
It is normal for the emergency flashers to work with key on or off. You need to shut the e-flashers off with the e-flasher switch.
You mean the one that controls the four-way flashers? It's on top of the steering column.
The turn signal switch in the colum could be bad COULD B the TurnSignal switch OR the Flasher 4 the Emergency FLASHERS (because there is 2(two) Flashers & the Brake light Switch on the Brake pedal could B Bad.(turnsignals Have there OWN Flasher) the emergency flasher switch has 3 electrical contacts.sometimes they overheat and melt into the red flasher switch deforming the whole switch.unfortunatly the whole blinker and flasher needs to be replaced.
There are 2 one under the dash near the steering column for the turn signals one under the glove box for the emergency flashers (switch in glove box)
I think these had a small metal round knob somewhere by the key. The switch will be in the column if that's the case & you will have to pull the wheel.
Bad switch in steering column? diffrent fuses.
perhaps the flasher unit burned out or the switch is bad.
You may want to check the brake lights.Everything runs through the multi-function switch.(the turn signal switch)
the flasher and hazards are all in one . if flashers are bad check hazard switch on dash. remove trim plate and remove screw that holds flasher switch in.
Module part of Hazard warning switch
Because the hazard/turn signal relay has failed. A defective/intermittent turn signal switch can also cause this symptom.
Try turning the hazard flashers on and off a couple times, see if that starts your signal lights working. If so, replace the hazard switch/module.
Probably the turn signals , hazard flashers , high beam headlights etc. like it does on my 1995 Ford Explorer
The turn signal flasher switch is mounted on the steering column left side. The hazard light flasher switch is is the red triangle mounted on the dash dead center between the A/C vents.
Are you asking how to change the Hazard switch? What makes you think it is bad? They almost never go bad and I would be really surprised if it were. Have you replaced the Flasher Relay for the hazard lights.