The Toyota Camry has a weakness with tail lights and break lights. The Camry uses a sensor, called the "Lamp Failure Indicator Sensor", and if it burns out, you will lose your tail lights, or brake lights, or both. This sensor is a small 2 inch box, which comes in different colours, like yellow, white, grey, for example. It is located in the trunk, driver side. You have to lift up the coverings, and it is attached to the wire harness. If you can find it, just unclip it and remove it from the car. Then, open the back of the box, and check the circuit. If there are burn marks, or some wires are broken, then that's the problem. A brand new sensor can cost 200 to 300 dollars. You might find one at the wreckers. They usually charge 5 to 10 dollars.
Brake light switch ?
Check the bulbs, the fuse and the brake light switch.
is my car safe to drive if the break light and abs light is on in my 2007 Toyota Camry
Check the wire which is going inside of the trunk hood to the brake lights.
Look in the owners manual. I think they are fused separately.
Check bulbs Fuse Stop light switch
it means u have to change your brake lights
A Toyota Camry built in 1998 takes DOT 3 brake fluid. This is the standard brake fluid for passenger cars.
First check the bulbs. If they are good then the switch that is connected to the brake pedal could have gone bad. Hope this helps.
please tell me how to open Toyota Camry 2005 le, rear brake light bulb
1 of 3 reasons why, your head lights are on, your reflector lights are on ,or your brake sensor is broken
The cheapest place to buy brake pads for a 2007 Toyota Camry is Pep Boys or Auto Zone.