0
Why would your brakes squeek on your 98 slk mercedeswas told breaks are fine?
Billerica71
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is the crunching noise from your brakes?
Does it squeek? Or is it grinding? Possible sand/ gravel trapped in your brakes. Or you need some new pads. If it's during winter and you break hard and start sliding.. then it would be your ABS kicking in.
What would cause your front breaks to wear out fast?
hard breaking or no back brakes. also, back brakes adjusted wrong.
My breaks squeek and their no metal to metal grinding and i need to know where to put in the brake fluid on a 98 Plymouth breeze?
If brakes are squeeking and you are low on brake fluid Probably time for new linings or pads, I would check them before just adding brake fluid. Brake fluid resevior should be located on firewall on driver's side
How do you remove brakes on 2000 dodge caravan?
anyone in there right mind would not to remove breaks on a car. Really!!
Why does your breaks make a knocking sound when you stop hard?
you brake shoes might not be seated right, or they might need to be replaced i would take it to a jiffy lube of a just brakes and get them to go over your brakes
Why are your back breaks locking up on your 94 grand am se?
if back brakes are drum i would think they are worn out not allowing pistons in wheel cylanders to return. also could be valve in master cylander.altho that would cause all brakes to lock up. if disk brakes your calipers need overhauling or replacing
Why would the brakes squeal only after reversing on a 1970 Bug?
in VW's when you have the breaks adjusted out too far they tend to grab when reversing. There is an auto adjuster in the rear drum to keep your rear brakes adjusting. If the brakes are worn out they will "hang up" after reverse and cause squeeling.
What is wrong with your 98 Ford Escort Zx2 if the brakes squeak after you release after stopping and when slowing to a stop something near the wheels is grinding Replaced all wheel bearings?
i would say you need to replace brake pads and clean drums and rotors with a good brake cleaner, also if pads are of a metal compound, you will never stop then squeeking if they squeek when released i would check that brake calipres and cylanders are not sticking, which does not allow brakes to release properly
How can you clean squealing brake rotors?
Same way you would clean rotors that don't squeel. It won't fix your noise problem if that's what you're going for. Also, if you have to ask this question you probably don't have the skills needed to take apart and service your cars brakes, remember this is a system that has to perform flawlessly or someboady could get killed. Frequently brakes squeek for several reasons and a build of dust or dirt isn't one of them.
Adjusting abs brakes 98 s-10?
You would adjust the brakes on a vehicle with abs brakes the same way you would adjust the brakes on a vehicle without abs brakes.
Where can you find a diagram of the rear breaks for a GMC suburban?
The rear brakes on your suburban are the most common of all G.M brakes. You should be able to find a diagram in any Chiltons manual.What I would recommend not trying to replace them until you learn how to spell BRAKES!! Make sure you know what drum size your dealing with also if they can't be turned.
What would cause your car to squeek constantly while you drive it?
A bearing, bushing or other rubbing surface has worn or dried out, or the brakes have worn down to the wear sensor. Either way, it's not a good thing. If the noise changes pitch when you touch the brakes, it's probably the brake wear sensor, get the brakes fixed right away. If not, it could be a dry wheel bearing, U-Joint (if your car has them), serpentine belt or who knows what else. Try to localize the sound. See what's causing it. Noises like that shouldn't be ignored.
