In short, yes. The 97-06 Wranglers all have the same bracketry but the Rubicon had a CV drive shaft where our X models have a non-CV shaft. A slip yoke eliminator (SYE) kit and CV shaft would allow your X model to become a Rubiclone for less than a real Rubi.
if its off an 03-06 rubicon. the jk's have different bolt patterns
03
All '03-'12 Jeep Wrangler Rubicons have 4 seat belts. 2 in the front, 2 in the rear.
no it will not the cut off i believe is at a 1996 then it goes 97-03
03 yes, any other year will most likely be different.
American Rubicon was created in 2009-03.
Rubicon - Tristania album - was created on -20-03-01.
Yes it will. All 97-06 TJ tops are interchangeable. Actually NO it will not fit. Jeep changed the windshield design slightly in '03. '97 to '02 will interchange, '03 to '06 will interchange. Another point to watch is whether you have a TJ or LJ, LJ's WB is about 10" longer. So a TJ top will not work with an LJ and obviously vise verse.
Yes. The only difference in the 97-02 and 03-06, is the sleeve to go over the rear bar has 4 domes on it in the 03-06 model tops.
A model of Jeep made from'03- current. It has front and rear D44 axles with air lockers, as well as 4.10 gears (unless intentionally changed when ordering from factory in newer models). It also comes with a beefed up transfer case that is better suited to off-roading.
I run 35X12.50R15 bfg mudders on 15X8" rims. it gives them a narrower look but they run fine off road and on the street. I have an 03 wrangler.
It's the pink antifreeze