In short, yes. There were very little changes to the 500 over a span of many years. Double check the mounting locations just to make sure but it should work fine.
NO.
although possible, it is not recommended. The actual cast engine block is the same however, the intake manifold and exhaust manifolds are to wide to fit into the z31 engine bay. So it is possible but would take a good amount of custom fabrication. I'd recommend an sr20 or rb series motor swap. considerably less modification
no
0.18mm to 0.22mm intake and exhaust are the same
The last year the Chevrolet Celebrity was produced was 1990, not 1992. And although there were some minor changes, the car was largely unchanged between 1986 and 1990. The standard I-4 engine is exactly the same, as well as the frame and body. I believe the headlight arrangements may have changed, as well as some of the dash detailing and the standard radio, but overall the car is largely the same.
No such thing as a O2 Sensor Box. The O2 sensor is located somewhere on the exhaust system. Looks similar to a spark plug with a wire connected. May be more than one. The o2 sensor on my 1990 Mitsubishi Mirage 1.5L (same engine as the colt i believe) is on the exhaust between the manifold and the catalytic converter
Engine specific. T he headers need to bolt onto the exhaust ports on the engine so regardless of the car the engine must be the same
Not necessarily. I took a look at a supplier and if you have the same engine, the front pipe is the same number. It is very likely that since the car bodies of these two are from the same series first generation Outback, and they have the same engine, the exhaust will interchange.
If same engine, yes.
yeeupp. Everything is the same besides the exhaust manifold...
yes if it's the same motor
The 1990 325i has a M20B25 motor. The earlier 1990 525i had the same motor, a M20B25, whereas the later 1990 525i had a M50B25.