yes they all have the same rear ends
The rear axle bearings on a Honda 300ex are replaced by first removing the rear wheel. The bearing cap and retaining ring are then removed and the bearing is then pulled from its housing.
When an axle breaks on a 1994 Honda Civic it is less expensive to replace it rather than repair it. Replacement axles in labor costs under $300 per side.
The torque for the rear axle nut on the 1996 Magna is 63 ft-lb. That's from the Honda Service manual. Hope this helps you out.
removing an axle from 98 Honda accord
It is located an axle that connect your wheel to the transmission. If you look under the car, it is the part that has two rubber "boots" on both ends. one end is by the wheel, the other, in the transmission
To replace the axle on a 1993 Honda Civic the axle nut has to come off. The hub assembly also will need to be pulled back so the axle can be pulled from the transmission.
Did you get an alignment after replacing the axle?
American Axle was created in 1994.
A 1994 Ram 1500 has a Dana44 front axle. A 2500/3500 has a Dana60 front axle.
definitly
Much better to replace the whole axle, look at www.happywrenching.com for a guide on how to replace an axle in a Honda Odyssey
How do you remove the front axle on 1998 Honda 450 foreman?Read more: How_do_you_remove_the_front_axle_on_1998_Honda_450_foreman