Chevy Silverado
Chevy Trucks and SUVs

Will a 2006 Chevy truck engine bolt up to 1974 Chevy trans?

789

Top Answer
User Avatar
Wiki User
Answered
2009-12-13 18:00:30
2009-12-13 18:00:30

No it will not, Not even close.

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


No it does not, Unless someone has MODIFYED it.


You have to use the flywheel for the 1974 engine and the clutch plate for the Trans Am.


Nope.....Chevy will only bolt to Chevy. The other brands....Buick, Olds, Pontiac and Caddy share the same bolt patter.


I have a 1974 Chevy truck with the 350 V8 and the engine is in good shape. At idle the oil pressure is 35-40 PSI, at driving speed it goes up to about 50 PSI. Hope this helps.


the seats out of 73 to 88 Chevy or a gmc


Typically for automotive and light truck applications it would be 5 qts with filter change.


The 1974 Chevy truck has a mechanical fuel pump with a built in pressure regulator.


Need to know how much is so much. A 1974 Chevy 3/4 ton 4X4 with the 350 engine probably got 10 to 12 mpg brand new. That's the way they were designed.


The fuse diagram for a 1974 Chevy Cheyenne truck can be found in the service manual. It details the location of each fuse and its purpose.



0 to 12,000 dollars depending on condition and milage.



attach a dwell meter and set the points for 30 degrees.



It does not have a sensor, It has a switch and it is mounted just above the brake pedal.


YES. The 74 and 86 engine blocks are the same as far as DESIGN.


400 small block 2brl was the basic engine with a 454 big block optional


Either drop the tranny or pull the engine.


A 1974 Chevrolet C10 pickup, Fleetside, Long Wheel Base, 2 wheel drive, sold for $3,153 brand new.


my truck is 1974 ford pick up


If that is the factory engine, Then it will be a tall deck engine that is designed for LOW END TORQUE/ BIG truck engine. You need to find you a 427 That came factory in a early model CAR are PICK-UP to build. But either way it will COST alot of money to build a hot rod BIG BLOCK that will stay together.


1974 c65 chev. w/ 366 , need spark plugs


Rpm needs to be set at 800 - 900 .. that is factory setting.


Whether you do it through the valve covers or elsewhere, yes the engine needs positive crankcase ventilation.


Depending on what the engine was used for, most likely dish top pistons. But flat tops ARE possible.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.