Yes.
I'm sorry but this answer should be NO, a 351w has a longer stroke than its little brother the 302 making the 351 intake a little wider than the 302 intake.
No , the 351 intake manifold is wider than the 302 intake manifold
Yes, a 351 windsor intake will fit a 302 engine as long as it is a 1976 or above. Although you will have to change the bolts, but yes it will work. 38 year certified mechanic
the cylinder walls are thicker but you can still swap the heads from a 351 winsor to a 302 and also the stroke is longer kinda like the 302 is a stroked 289.also if the motor is together the intake is much wider than a 302
the 302 flywheel is the same as as the 351.I just converted my 79 van 351 with an automatic tranny to a 5 speed manual from a 302.everything bolted right up.
The 302 boss has slightly bigger heads, it comes stock with 351 Cleveland heads.
this one i know thru experience,and a long time to figure it out. but yes a 302 cam will work in a 351.but, u will need to time the engine to 302 timing specs, not to 351 timing specs the same applies if you put 351 cam in a 302
First thing is count the valve cover bolts. If it has 6 then it is a 302 or 351.The 351W has a taller deck height than the 302. (a 302 will have the intake almost flush with the base of the distributor... where it goes into the block..... a 351w will have about 1/2 inch lip there where the intake meets the block.) The lower thermostat housing bolt on the 302 will be below the top of the water pump and you won't be able to put a socket on it. On the 351W you can remove the bolt with a socket. 351C manifolds are dry, no water passages or thermostat housing....thermostat housing goes into the front of the block. 351w uses 18mm spark plugs and the 351c uses 14mm spark plugs. 351w fuel pump bolts are on left & right sides. 351c fuel pump bolts are on the top & bottom.
Unlike chevys 305, 350, and 400 which are interchangeable. The Ford 302 and 351 are not interchangeable.
They should fit a 351 windsor.They will not fit a clevland.
pretty much any 302, or 351 heads will fit
no, the 302's would most likely blow the 351, if its a big block
No, the 351 W was a wider lifter valley and the intake will not interchange