No, completely different.
No, completely different.
No, completely different.
It is on the passenger side of the bell housing about half way up.
It is the two wire sensor on the passenger side of the transmission case.
It is on the firewall side on the of the transmission close to the engine about half way up.
CV joints on any car are part of a "half-shaft," and they run from the wheel to the transmission.
No
Only if you swap the back half of the trans from the 4wd to the 2wd.Only if you swap the back half of the trans from the 4wd to the 2wd.
In 1914, Dodge made a half-ton Panel Van, but no actual pick-up truck. In 1921, Dodge began selling Graham 1.5 ton pickups, which were Graham bodies, using Dodge parts and sold through Dodge dealerships. By 1926, Dodge owned Graham, so after that, Dodge trucks were technically all Dodge produced.
No dipstick, you remove the plug that is about half way up the side and the fluid should be level with bottom of the hole.
how to chance a CV shaft on a 1997 dodge stratus
Half Ton
No.
half and heavier.