answersLogoWhite

0


Best Answer

the simple answer is yes, but more difficult to say, and i found out the hard way is that none of your factory components (ecm, injectors,trans, rear end etc) will handle the power that the 402 puts out.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Will a Mopar 402 crate engine bolt up to a 99 dodge ram with a 318 in it right now?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is the point gap settings on a 318 mopar engine?

.o17 is about right


Advanced Auto found my engine in one of their paper publications listing it as a 1971 factory crate engine from GM 350 with 374hp Is that true Anyone know if they had 71' crate engine rated 374?

That doesn't sound right. Try Mortec.com for additional information.


How much does it cost to get a Chevy cavalier Z24 engine?

There is a brand new crate engine on eBay for right now $950.00 07-18-08


What size engine does a 96 Dodge Stratus have?

The engine size in a 96 Dodge Stratus is a 2.4 liter could have a 2.0L. It should say it right on the engine.


What type of transmission fluid to use for 2002 dodge caravan se?

It is important to use the right type of transmission fluid to keep a car running well. A 2002 Dodge Caravan Se uses Mopar ATF+4 transmission fluid.


What and where is the tranny on a 1996 dodge neon?

the transaxle is located to the right, slightly below and attached to the engine on a dodge neon


If you push on a heavy crate to the right and it slides what is the direction of friction on the crate?

The direction of friction on the crate is opposite to the direction in which it is sliding. In this case, since you are pushing the crate to the right, the friction will act to the left in order to oppose the motion.


Can you change out your 318 Dodge engine for a 360 or 383?

WELL FIRST OF ALL THE 318 AND THE 360 USE THE SAME ENGINE BLOCK (LA) JUST DIFFERENT HEADS AND BORE SIZE, AS FOR THE 383 ITS PART OF THE DODGE BIG BLOCK FAMILY (RB) AND THAT CAN BE DONE BUT SUSPENSION MAY NEED TO BE DONE DUE TO THE EXTRA WEIGHT BUT IM PRETTY SURE IT CAN BE MOUNTED IN WITH THE RIGHT MOUNTS AND IT MAY DEPEND ON WHAT AUTOMOBILE ITS IN SO GOOD LUCK GO MOPAR


Where is the crankshaft sensor on a 96 Dodge Durango?

Dodge did not produce the Durango until 1998. It is located on the bell housing on the right side of the engine where the transmission mounts to the engine


Where the engine computer located on a 2001 dodge stratus?

under the hood on the right side, right on top


Where is the air filter on a 1985 dodge 350 van?

Right on top of the engine.


Where is the purge solenoid on 2002 dodge Dakota?

To the right of the battery, when looking at engine.