Yes, it will.
An onboard diagnostic scan would be a good first place to look.
what to look for no fire from distributor on 5.2 liter doge ram
Below the water pump and above the crank pulley.
There is none. The engine ECM signals each spark plug coil when to fire.
Check to make sure your getting fire at the Distributor Cap, if not, then try replacing the cap and rotor button. If that doesn't work, you may need a new distributor.
Not a chance. It tells the distributor when to fire.
Technically, #1 can be at any of the 8 points if the distributor has been replaced and the mechanic didn't install it the same as the factory. #1 on the distributor is wherever the rotor is pointing when #1 cylinder is mechanically ready to fire.
I would start with replacing the spark plug wires and spark plugs (if you did not do that for a while). If does not help check the coils or distributor depending on what you have.
Could be the distributor. That just happened to mines.
The spark travels from the coil to the distributor then from the distributor to the plugs. So if you have spark going into the distributor but not coming out to the plugs, I would blame the distributor cap and rotor being at fault.
My 2001 Toyota camery cut off while driving want crank sound like spining but not fire or out of gas batteys good alltenater good fuses a good can you help me the car is at 150,000 miles
The engine may not fire when the distributor coil is broken. Replace the distributor coil to see if the problem is resolved.