Yes, the bellhousing is a tad diffrent... But it will still bolt right up and get the job done. I am not 100% sure on the automatics, but the 5-speed's bolt right in.
Yes it will , S14 transmissions also have an unnecessary crank angle sensor on top of the bell housing you can remove.
I wouldn't know eactly, but here something may be it'd be helpful. 1. Find out if KA24DE and KA24E have the same engine block. if it is, then it should fit. 2. KA24DE and KA24E Trans Auto/5-Speed Fits Perfect. 3. You can easily find out just by looking at the oilpan gasket. Check out oil pan gasket for a KA24DE and KA24E and see if they match size and shape. Bolt size are usually/most likely to be same, since it IS KA series engine.. Hope that helps... goodluck.
Well if you look at the 240sx you will see that although the engine size is the same KA24E the engine on the 240sx is SIDEWAYS.
If you're talking about the KA24DE engine block, then it will fit with no problems since your 92 already came with a KA24DE in it. It should work fine. It's the same engine in both years.
yes either trans will work basicly the same motor (ka24de) only difference is emissions and obd crap same mount and everything
The engine may work, but the transmission is not the same. With enough time and money it may work, but it won't be easy.The engine may work, but the transmission is not the same. With enough time and money it may work, but it won't be easy.
ABSOLUTLEY!!!! it is the same engine , havent you actually looked and compared? in fact this same engine (KA24E) is in early 240s. good luck with your swap!
The engine turns the transmission then the transmission turns the driveshaft.
In theory, if you can find a transmission housing, flywheel, and clutch that will attach to this engine.
Yes
no, not at all. the newer VQ engines are rumored to fit, but you have a lot of work to do with the ECU and engine management when you do that. Best/easiest bet is to turbo that ka24de.
If that 700R4 was attached to a mechanical engine (or even a TBI engine, which only had basic electronic functions), it's not going to work... there's no engine ECM for that transmission ECM on the 4L60E to interface with.