No it won't I'm afraid, they're just too different.
yes mate it will no modifications will be needed at all. the zetec -s body kit fits directly onto mk1 and mk2 mondeo's |The "Zetec S" bumper will fit the zetec engined models but will not fit the V6 as the exhaust exit for the V6 is on the right hand side. So in a nutshell Zetec S (RSAP) rear bumper will fit the 2.0, 1.8 & 1.6 models (exhaust on left) and the ST24 (RSAP) bumper will fit the V6 (exhaust on right) It also depends on model of car. Only the Saloon and Hatchback are interchangeable, the estate bumpers are completley different Hope it helps :-)
you havent said if its a mk1 or 2 but have just recently changed my mk1 front bumper and is straight forward. If you put your car on ramps or axle stands and get underneath the car, you will find you will have to remove the splash guard with a Allen key, cant remember what size but these are all accessable. Once this is removed then proceed to look up in line with the wheel arch lining on both sides and you will see 2 bolts on each side of the car, these are 13mm. undo these and then undo the screws holding the inner arch lining out and just pull the front bumper off its slide mounts at the sides and the whole assembly comes out. Hope this helps you with your problem you havent said if its a mk1 or 2 but have just recently changed my mk1 front bumper and is straight forward. If you put your car on ramps or axle stands and get underneath the car, you will find you will have to remove the splash guard with a Allen key, cant remember what size but these are all accessable. Once this is removed then proceed to look up in line with the wheel arch lining on both sides and you will see 2 bolts on each side of the car, these are 13mm. undo these and then undo the screws holding the inner arch lining out and just pull the front bumper off its slide mounts at the sides and the whole assembly comes out. Hope this helps you with your problem
You can't (wheel arch is in the way)
yes if you change the slam panal front wings headlights and the bonnet lol
yes the mk1 fisheye is made for the sony vx-1000. it will only fit a vx-2000/2100 if you mod it.
Yes,they are the same,i have done this.
Unlikely, the MK1 is four stud, a mk2 uses 5 stud
I would only use the wiring loom from a MK1, as the MK2 wiring could be completely different!
no scrap the escorts there heaps anyway. buy a focus mk1 escorts are crap
Does velocity dash fit in Golf MK1
no its front wheel only
The timing marks on a MK1 1600cc Caddy engine is on the front of the crank pulley. It is under the cam also.