I do not know that it would not work.I would strongly advise you NOT to use a older wiring harness in a newer model due to wiring breaking down,corrosion,brittle insulation.However you should check into something like http://www.painlesswiring.com which should offer a new harness,complete directions,and a sure fit for your model.Time wise and problems a new harness is much simplier and worry free not to mention the cost is prettty cheap and piece of mind.
the wiring order is 1342
A person can find a wiring diagram for a 1984 Mazda b2000 in its maintenance book. They can also ask for a print out at an auto part store.
The engine oil capacity for a 1986 Mazda B2000 is 4.1 quarts.
Yes, the 86-89 B2000 engine will bolt into the 86-93 B2200. There are two mounts that go from the engine to the transmission on either side, you'll need to transfer these from the B2200 engine onto the B2000 engine. You will also need to keep the lower radiator hose from the B2000. Mazdatrucking.com has additional information on engine swaps as well as forums.
yes
It is a triple rotor Rotary engine. A b2000 was there pickup.
Need to know what year.
The spark plug gap for a 1985 B2000 Mazda with a 2.0 liter engine is .8 mm. This is equal to .031 inches.
.012 int.-.012ex.
Connect the speedo with the corresponding adapter to the distributor cap, then run wiring to the cab and mount where desired.
under the termostat housing.
#1 is front cylinder, distributor rotates clockwise, firing order is 1342, timing is 6 btdc