It won't work as a skimmer if your water level is above the skimmer. If you watch how the skimmer works, the water is pulled in over the skimmer door and it won't "skim" the floating debris off the surface of the water if the water level covers the entire opening, your skimmer will just suck in water that is below the surface. If you keep the water level so it's at least below the opening an inch or so, you should be o.k. If you've recently had alot of rain, you may need to drain some water out of the pool so your skimmers function properly.
You can run the filter, however, you should drain some water out for maximum use, the skimmer will not skim the pool if the water level is to high. go to www.askpoolquestions.com for more info.
no the pool just wont skim
If you have the regular set up that includes a skimmer, pump and filter then you don't have to waste any water. Get an lid-to-hose adapter, that fits over the skimmer basket at your pool supply store. Fill the hose with water and attach it to the lid. Place the lid inside the skimmer over the skimmer basket, then vacuum to your hearts content. Pool Masters
I don't know why your skimmer is doing what its doing, However you can lwer the water level in your pool by vacuuming to waste OS backwashing.
A pool skimmer is generally built into the side of or around the top of a swimming pool in order to skim debris from the surface of the water. A pool filter is built into the plumbing in order to filter fine debris from the water itself.
The best way would be to unplug the swimming pool filter, open the drain valve on your pool filter turn the pump back on and drop the water level to the desired level about 2 inches above the skimmer.
It has to be filled above the skimmer ( flow to pump) or else the filter will not work. Also, if too low the liner may dry out above the water line and cause it to shrink.
The sound you hear is probably air mixed with the water. The skimmer isn't filling completely because there is not enough water in the pool
yes in order for the pump to work the water has to be over it
No. You cannot use the main drain to lower the water level below the skimmer. This is because the main drain is not really a drain. It only connects right back to the 3 port valve in the skimmer.
Firstly, the pump is not a sand filter system. The pump is the one with the motor attached and it pumps water not sand. The large round tank is the "sand" filter. You would have to find a skimmer made for vinyl pools with gaskets. It attaches to the wall of the pool and is seen "hanging" from the outside of the pool. The type of pool and equipment have no factor in choosing a skimmer. another good way to go is the Dragonfly Super skimmer this is a floating pool skimmer and only requires a hose to connect it to suction
For my pool, I do the following: Pool Opening: Add water to above skimmer Open heater and connect heating port inside Reattach chlorinator and lines Connect heater at grey lines Remove skimmer plug Remove rubber plugs from jets Reattach black plugs to pump (2) and to filter (1) Reinstall filter cartridge Take a water sample to a pool store for a free water analysis
If its a cartridge filter. Cut of the water from the skimmer as well as possible then take the upper cover of the cartridge filter take out the element and hose it down. Put it back together. start the pump often there is a valve on the top of these to let excess air out, open it until water starts to run out of it.
yes you can, just make sure that no one blocks the skimmer or the water return hole.