0
Will the fluid run out when changing a thermostat in a 97 Subaru OBW?
Wiki User
∙ 16y ago
Drain approx. 1 gallon from radiator prior to opening housing
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
Where is the plug for trailer wiring harness on Subaru Outback 2003?
On my OBW, it's in the left rear stowage compartment with the jack...
Where is the plug for trailer wiring harness on Subaru Outback 2.5 2003?
On my OBW, it's in the left rear stowage compartment with the jack...
A synonym of the anagram of obw?
Some synonyms for bow are bend, stoop, flex, arc, arch, or front of a ship.
Would anyone know of a good OBW holster for a SIG P250 full size with rail mount crimson trace laser and i prefer a polymer holster?
Contact Craft Holsters, DeSantis, Uncle Mike's and Optics Planet. There are several out there.
How do i change 2003 outback low beam?
On my OBW, I find it a lot easier to remove the Headlight Housing assy(that way you get access to all the bulbs), replace the faulty bulb by a Brand X H1-12V-55W(make sure you don't touch the glass), check if it's working & re-install the housing. Bingo...
What are some nine letter words with 2nd letter O and 3rd letter B and 4th letter W?
According to SOWPODS (the combination of Scrabble dictionaries used around the world) there are 4 words with the pattern -OBW-----. That is, nine letter words with 2nd letter O and 3rd letter B and 4th letter W. In alphabetical order, they are: bobweight bobwheels bobwhites cobwebbed
What fruits contain water?
All fruit contain water. The following fruits have high percentages of water in them: Watermelon (92% water) Strawberry (92% water) Grapefruit (91% water) Cantaloupe (90% water)
How hard is it to replace the knock and throttle position sensors on 1997 outback?
I replaced the knock sensor on my '97 OBW. I used a 12 mm socket with an extension to remove the bolt that is under the intake manifold. You can use a piece of bent coat hanger to fish the sensor and the wire so you can work on it. The sensor just plugs in so removal is not really difficult. then place the sensor back on the top of the engine and re-install the bolt. Be careful and take your time and it can be done.
