answersLogoWhite

0


Best Answer

If they are both 10 bolt, which means that 10 bolts holding on the rear end cover, and have 8.5" diameter ring gear.

User Avatar

Wiki User

โˆ™ 2005-11-25 04:26:35
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: Will the gears of a 1987 Chevy pick-up half ton rear end fit a 1991 Chevy pick-up half ton rear end?
Write your answer...
Submit
Sign up for more answers

Registered users can ask questions, leave comments, and earn points for submitting new answers.

Already have an account? Log in

Related questions

WILL A radiator out of a 1988 Chevy fit in a 1987 Chevy short bed?

Any radiator from a 1981-1987 pickup and as late as 1991 for the k5 and burb should interchange with minimal problems.


Does a 1991 Chevy s10 pickup have an inertia switch?

No it does not. Chevy did not use them in that year on there trucks.


Will the front clip of a 1993 Chevy 1500 pickup bolt on to a 1991 GMC 2500 pickup?

It sure will.


Idle speed adjustment for a 1991 Chevy cheyene pickup?

replace the ecm


What kind of grease goes in 1991 Chevy pickup rearend?

80 or 85W90 gear oil.


Where is the ecm on a 1991 S10 Chevy pickup truck?

Behind the passenger side kick panel.


Where is the fuse box located on a 1991 Chevy S10 pickup?

mine is located on the drivers side of the dash


Where is the computer located in a Chevy s-10 1991 pickup?

Behind passenger side kick panel.


Can you interchange interior for a 1991 Chevy silverado pickup truck with the years 1988 to 1994?

Yes there all the SAME.


What is the fuel pressure on a 1991 Chevy pickup?

9 to 13 LBS. No lower are higher are you will have starting and running problems.


How do you replace the modulator valve on the transmission of a 1991 Chevy S-10 pickup?

YOU can't. It don't have 1


Will a windshield from a 1987 Pontiac Bonneville fit into a 1991 Chevy Lumina Euro?

I doubt it


How do you release an engaged emergency brake on a 1991 Chevy pickup when the release handle broke off in your hand?

pull the shaft


What was the horsepower of a stock 1991 350 K1500 pickup engine with a dual barrel throttle body?

Chevy says about 210hp.


Where is the TPS located on a 1991 Chevy pickup?

It is located on the side of the throttle body, opposite side where the throttle cable connects.


What would cause all gauges in a 1991 Nissan pickup to go out?

Richey cintorino Check the fusable link, that caused all my guages to go off on my 1987 pickup.


How much does a 1992 Chevy pickup 4x4 weigh?

I have a 1991 K1500 4X4 it's aprox. curb weight is 5000 lbs.


Where is the Turn signal flasher 1991 Chevy pickup?

drivers side under dash by the fuse panel not on mine - it is closer to the radio


How do you change the oil pump in a S10 pickup 1991?

how do you change the oil pump on a 1991 s10 pickup


Where is the oil filter located on a 1991 Chevy 4WD S10 4.3L V6 pickup?

It is in the front bottom, there should be a scuff cover covering it.


On a 1991 Chevy S10 Pickup where would the manifold hose be located?

Sorry, There are about 30 answers to that question, Which one?. Good luck, Jamison


Is a 1991 Chevy s-10 blazer enter changeable with a 1999 S-10 pickup?

Some parts are but most are not.


What is the fuel tank Capacity for a 1991 Chevy 3500 pick up truck with a single tank and 454CUI engine?

It is important for the owner to know the fuel tank capacity of their vehicle. The fuel tank capacity of a 1991 Chevy 3500 pickup is 20 gallons.


Where is the oil filter on a 1991 Toyota base model pickup?

Where is the oil filter located on a 1991 toyota pickup


Is a 1989 pickup fender interchangeable with a 1991 pickup?

YES, They are the same.