yes,if both are 2.9 motors,both are 4wd, and you are talking about the bronco2,not the full size bronco
no the transmissions are different and it wont work.
I believe there is an information sticker that can be seen with the drivers door open Transmission code " D " is a Mitsubishi manual transmission Transmission code " X " is a Toyo Koygo 4 speed manual transmission Transmission code " 5 " is a Toyo Koygo 5 speed manual transmission on a 1987 Ford Ranger according to ( www . the ranger station . com , no spaces , click on Tech Library ) The website shows that the Mazda transmission was used from 1988 on
My owners book states 10w30 is the standard. --------------------------------------------------------------------------- That would depend on which 5 speed manual transmission you have in your 1987 Ford Ranger Transmission code " D " is made by Mitsubishi and takes ( 80w90 gear lube ) Transmission code " 5 " , Toyo Koygo , and takes ( ? )
large bolt head located on drivers, side of transmission.
probably the through out baring or ur trany is goin out
Dexron or Mercon III or one that is compatible with those two types. Power steering takes Type F Transmission fluid.
where is the fuel pump in a 1987 Mitsubishi Truck
Hard Knocks - 1987 Bronco's Rib - 1.5 was released on: USA: 29 May 1987
look under the driver side right beside the transmission there is a slide with a bolt and nut loosen them and have someone put the lever in place then tighten
passenger side rear of motor, it goes down the same tube used to check the transmission fluid levels, you will need a good funnell
The ignition timing for a 1987 Ford Ranger 2.0 L - 4 cylinder engine ( with manual transmission and 2 barrel carburetor ) is ( 6 degrees BTDC ) according to www . motorcraft . com ( no spaces )
Space Ranger - 1987 VG was released on: USA: 1987