Yes. If you do not want a big mess, I would suggest draining the tranny fuild before pulling out the half-shafts (axles)
yes it will fit they are all the same size..... from 92-00 civics vx dx hx ex and cx trims use all the same axels be it auto or manual
they connect the transmission to the wheels to make it move
First remove front axels, then remove the transmission, undo clutch bell housing. Add on new clutch pressure plate.....new clutch bell housing......put the transmission back in and axels
Any axles for Foreman from 1993 to 2000 will fit.
The speed sensor is located in the back of the transmission, in between the axels.
check your tie rods for play as well as your lower ball joints if that all fells good get your strut mounts looked at drive safe
Yes, you must pull both axles to change any transmission, Mazda or not.
The drive line is the transmission,rear ends,driveshafts, transfur case and axels.
so far i have removed the both axels and the wiper's assembly and air intake,tires.brakes
the pedals , driveshaft, shifter. and stub axels. speedo cable.
It has 2. One left and one right front axels
You can cross in a semi truck. The rates for commercial trucks over 10,000 pounds are $4 for 2 axels, $6 for 3-4 Axels, $10 for 5 axels, and $12 for 6 axels.