Want this question answered?
If three identical bulbs are connected in parallel to a battery, all three bulbs would have equal brightness.Kirchoff's voltage law states that the signed sum of the voltage drops around a series circuit is zero. A consequence of this is that, in a parallel circuit, the voltage across each parallel element is the same.There are effectively 6 series circuits in this example - battery and A - battery and B - battery and C - A and B - A and C - and B and C. These six combinations are also parallel circuits, and they are also in parallel with each other.
As the lamps are identical, and all three draw a current of 6 A, then each lamp must be drawing 2 A. So, with one of the lamps disconnected, the current drawn from the supply will reduce to 4 A.
12V. Every resistor in a parallel circuit shares the same voltage. It is the current that gets divided.
Fuse, flasher, switch, bulbs, wires, ignition not on, dead battery,Fuse, flasher, switch, bulbs, wires, ignition not on, dead battery,
More than likely there is a short in your electrical circuit either between the headlights and your switch or in your Headlights fuse. Check under the bonnet near the battery for a fusebox then check for the Headlights or Headlamps fuse then check to see if the fuse has been blown (the fuse will be in a seethrough casing and the circuit will be separated). Another good tool to get for yourself is a simple voltmeter, you should be able to find a voltmeter for about 10 to 30 euros and then read the instructions. When checking for automotive circuits set your voltmeter for DC voltage then place your positive probe on one part of the circuit and your negative probe on another part and note the reading. If the reading fails to read toward normal voltage (12-14VDC) then you have identified the shortcircuit and may be able to replace the shortcircuit or inform your mechanic or dealership or agency of your problem.
it takes 1 C type battery <><><> That answer is not really very helpful because the question doesn't say what the voltage of the light bulbs is! This question cannot be answered without knowing at least the voltage of the light bulbs and also the voltage of the battery that is being asked about.
As a series circuit, as asked, all bulbs will go off because of that just one bulb.
I have a 3 year old who was always turning on the back reading lights. Then the next morning I would come out to a dead battery. I just removed the bulbs for a short term fix and will replace them when she gets older.
A battery is creates an electricflow and is used to power anything like light bulbs, motors and buzzers.
In my experience, the battery fails first.
yes! connect all the bulbs in parallel.. i.e. battery positive terminal will be tied to one side terminals of bulb and other terminal to the other. but it will result in less power delivered.. and fast battery usage..
Yes you can but it will drain that battery quickly.