It should, but that depends on the manufacturer and dealership. * Most powertrain warranties define "powertrain" as internally lubricated parts of the engine and transmission.
If you are under 50,000 miles and 5 years you let the dealer take care of it! Replacing the bulb in an 2006 SRX requires the removal of the entire front bumper. So whether in or out of warranty I'd let the dealer do it.
It could oil pan gasket, or camshaft oil seals, or rear main seal (crankshaft), or crankshaft front seal, or oil pump gasket, or oil pump seal. I would start with the oil pan gasket. Before doing anything make sure that climb under the car and check where the oil coming from.
An oil leak there is probably a valve cover gasket leaking. it would not require head gasket replacment. Try tightning the bolts on the valve cover. If that does not work then replace the valve cover gasket. Yes it could be the head gasket as there are oil passages in the head and i have heard that head gasket on saturns are prone to failure,look around the valve cover for sings of a leak hopfully that's all it is because replacing the head gasket is costly on th 1.9 sohc
there is no upper intake gasket, only a front and rear
there is no lower intake gasket, only a front and rear gasket
Whats the procedure for replacing a 2002 Buick Lesabre front strut.?
depending on quality and warranty. 20 to 60 for front pads.
The majority of the stopping power is performed by the front rotors. I would start by replacing them.
I'VE BEEN TOLD A SHORTCUT TO REPLACING THE WATER PUMP IS TO REMOVE THE EXHAUST MANIFOLD AND THE WATER PUMP WILL COME OUT EASILY. THEN OF COURSE, YOU HAVE THE EXPENSE OF REPLACING THE EXHAUST MANIFOLD GASKET AND EXHAUST O-RING GASKET. BUT A LOT CHEAPER THAN REMOVING THE WHOLE FRONT OF THE MOTOR. Try a chiltons manual or www.alldata.com If this is a quad four motor, you may not want to try this at home.
Repairing a car can be costly. The cost to repair a Front Valve cover Gasket can range from $15 to $150 or more.
Sounds like water pump needs replacing The main pulley is near the top of the engine. The water pump is toward the front of the engine. It is possible that water appears to be leaking from this pulley, but there is a manifold gasket right above it. Double check to find exactly where the water is exiting the engine block. My first hunch is a leaking gasket.
Yes, it would be called a cold front, as the cold air is replacing the warm.