0
Would would the washer pump not work on a 2000 Accord fuse is good no clicking noise when pressed do not believe the pump is defective what else could be wrong?
Wiki User
∙ 18y ago
it could it is almost 6 years old, there cheep go to advanced, auto zone
Wiki User
∙ 18y ago
Add your answer:
Earn +20 pts
98 accord ex manual trans are the front rotors slipped on or pressed on?
They are not pressed on.
Do the front wheel bearings on a 1991 Honda Accord have to be pressed out?
yes they do. I have a 1991 Honda civic and I needed to press them in and I believe they have the same front end.
94 Honda accord radiator fan not turning on?
Blown fuse, defective fan motor, or defective thermal relay.
How can you tell if the rotors on my 2001 4cy accord are pressed on?
If the rotor of the 2001 Honda Accord will does not have mounting hardware it is pressed on. To remove these types of rotors the caliper will have to be unmounted. The rotor will then come off.
Why did the blower motor on an 04 Honda accord stop working?
Blown fuse, defective blower motor, or defective resistor pack.
How can the drivers side floor get wet on a 2000 Honda accord?
Defective windshield seal? Defective door seal or door not adjusted properly?
1999 Honda accord cooling and radiator fan has stop working?
Blown fuse, defective thermal relay, or defective fan motor.
How do i replace front studs on my 1999 Honda accord?
Front studs on a 1999 Honda Accord are pressed in. First the studs must be removed using a hammer or press. Once remove each stud can be pressed in.
Is the front wheel bearing in the hub assembly of a 2001 Honda V6 accord a separate unit or is it pressed in?
just replacd myself. it is pressed in. it will actually come out however it needs to be pressed back in.
How do you change the front rotors on a 1999 Honda Accord DX?
they have to pressed out from a machine shop.
Why don't my 1989 Honda accord turn signals and flashers work?
Flasher relay is defective. Replace it.
How do you fix a faulty master brake system on a 1995 Honda Accord?
If the Master Cylinder is defective then replace it.
