Want this question answered?
Due to poor trophic transfer efficiency, most energy is lost at higher trophic levels.
The boiling point is always higher than the melting point.
depending on voltage supplying the bulb, each ballast spicifies on it such rating. many ballasts have better efficiency at higher voltage. however; say 175 watt bulb, 120V with 80% efficiency= (175/120)/.8=1.82amps
That is not always true.
7, lower is acidic, higher is basic.
This is not always true. Other systems may be utilized more than this faster system for other reasons not listed here.
The relationship between friction and the efficiency of a machine is when friction increases, efficiency decreases, and vice versa. That is why you can never have 100% efficiency, because there is always at least a little friction. They are inversely proportional, meaning, higher friction equals less efficiency.
Mistakes always cost more than successes.
Biodiesel
It is efficiency of the propelling device in converting the applied torque into useful thrust. In an IDEAL propeller the freestream velocity and the slipstream velocity should be same. The higher the exhaust/slip stream velocity, higher is the wasted kinetic energy. Thus turbojet engine has lower propulsive efficiency and turbo-prop engine has higher propulsive efficiency.
The efficiency of air conditioners is often rated by the seasonal energy efficiency ratio (SEER). The higher the rating the more efficent the air conditioner is. A common misconception is that the SEER rating is also used on heating systems but it's only for air conditioners.
Optimum Utilization of Machine means to use a Machine in such a way that we produce at the maximum capacity after spending its minimum maintenance and other variable cost. In Short, Higher Productivity in low Cost.
Seasonal Energy Efficiency Ratio - the higher the number = more energy efficiency of the unit
Efficiency is like a ratio. The higher the efficiency the less you have to put in or the more you get out. Performance is just how fast or how much it can make of something. Example: A hybrid car has a high efficiency because you get more mileage than say a muscle car, but the muscle car has higher performance because it goes faster and has more power.
Outlets in rural-urban fringe areas are often located higher due to the topography of the land. The higher location helps prevent flooding and water damage during heavy rainfall. Additionally, placing outlets higher can also improve the efficiency of drainage systems by utilizing gravity to assist with water flow.
The pH in tropical systems should never be that low. Tropical systems need a pH of around 7.8-8.4. Always a little high with higher salinity and temperatures as well.
Frederick W Taylor was the father of mass productiontechniques.