0
You Have A 1992 Bonneville replaced the crank sensor it worked for about 2 weeks now you can drive it for about 10 minutes and it stalls like it running out of gas?
Wiki User
∙ 15y ago
You should have changed the cam & crank sensors at the same time. I think your problem lies with your ground for your fuel pump is interrupted. Had the same problem and that was the answer. The ground is located under the dash and the wire has probably been pinched so I bypassed that by grounding my fuel pump in the trunk area and my problem was solved. Good luck!
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Your 1998 Bonneville will not start have replaced the battery the starter was replaced last year do you have any ideal what it may be?
COULD BE THE CRANK POSITION SENSOR
Where is crankshaft sensor on 1992 Pontiac Bonneville?
my son just replaced one on my car i also have a 1992 Bonneville it is located on the passenger side frount behind the tire you will need to remove your tire
Where is a knock sensor located at on a 96 Pontiac Bonneville?
where is a knock sensor located on a 96 Pontiac Bonneville
1989 Pontiac Bonneville starts fine but quits after about 10 minutes then starts again but wont stay running?
The 10 minutes is generally the time it takes to heat up your oil. As it gets to the high temperature, it causes the Crankshaft Sensor to fail. Had this exact issued on my 1989 Bonneville. Easy Test: The CSS is on the bottom right front of the engine with its sensor head in the crankshaft (bottom of serpentine belt). When it is about to temperature of OIL, not water, spray some water on that area of oil pan. You should continue to run fine. Simply replace the $50 part, and you are done. Had this same thing, with just a bit less frequency happen to my 1997 Bonneville! Replaced the CSS and it runs fine.
1994 Pontiac Bonneville?
where is a map sensor loction for 1994 ponatic bonneville?
Why would a 1992 Bonneville SSE stall while driving and start back up a few minutes later?
I have a 1995 Bonneville that did the same thing. Your problem is you have a bad crank angle sensor. When you run your car on the computer it will not show up, but that's what your problem is. I took mine to the dealership and it was replace, cost about $230, and it has not happened since. Been about two years since replaced.
How do you change the ABS speed sensor on a 1993 Pontiac Bonneville also need to know the do's and do not's for this procedure?
The speed sensor may be built into the hub bearing. In that case the whole hub bearing needs to be replaced.
What does map sensor run on a 2003 Bonneville?
about $50
Where do you find the camshaft sensor on a 1987 Pontiac Bonneville 3800 V6?
The cam sensor on a 1987 Bonneville is just below the water pump, it has a gray electrical connector.
How do you replace a blower motor on a 1997 Bonneville?
The blower motor on a 1997 Pontiac Bonneville is located next the evaporator core. It will be mounted behind the glovebox on the passenger side of the vehicle. Remove the glovebox, mounting hardware, and sensor clips. The blower motor will be able to be replaced.
Should a new motor be purchased when a crank shaft sensor needs to be replaced?
no no no my crank sensor when out on my truck ar 95k now i have 125k and she is still running good
Change a throttle position sensor for 05 altima?
The throttle position sensor determines the amount of throttle used when the engine is running at various speeds. If the sensor is faulty, it can be replaced by ordering a new part.
