check the vaccumm hose coming from behind your master cyilder there you will find a brake booster that the master cyilder is bolted to and there should be a vaccumm line going to your engine make sure its all hooked up
no that would not cause the abs light to come on. If it had a vaccumm leak it would miss. but it runs mine i just blown a brake line and fixed it and the abs light is on and its got a real stiff peadel
the brake pedel pushes a switch right on top of the pedel lever it can come loose or go bad. check fuses first
brake light switch is mounted by the brake pedel remove lower panel above brake pedel and then you will see the switch should be able to turn the switch to replace
adgust the brake light switch at the brake pedel under the dash
the brake light switch at the pedel is bad and stop it from coming out off gear see you have brake light if you don,t that's your promblem
The Parking Brake
special bit for light lens cover, t 10 or t 20 bit light bulb unscrew from socket replace observe ligh light place foot on brake , re screw use brick on brake pedel
There is air in your brake system. Have it checked ASAP. You have a fluid leak somewhere.
first unbolt the brake fluid resovor then unbolt the rod that goes threw the fire wall to the brake pedel, it unbolts from the pedel then unbolt the booster from the fire wall and there ya go
Push your emergency brake pedel down just 1 or 2 clicks and they will stay off. Just ignore the brake warning light on the dash.
you just put your RIGHT foot on the brake pedel and slowly and gradually press it in
above brake pedel behind fuse block
Under the dash attached to the brake pedal lever.