0
You have replaced the Master Clutch cylinderand the slave cylinder and the clutch still there is no pressure on the clutch peddle?
Wiki User
∙ 14y ago
I am having the same problem as you and for the most part people say that there must be a leak somewhere. Unfortunately, I cannot find any leak. I figure if it was too small of a leak the pressure would slowly deplete. And on the contrary, if it is a large leak it would be noticeable. I'm not really sure if you find out please let me know as well. Sorry I wasn't much of a help. nathanr1988@Yahoo.com
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you adjust hydraulic clutch on 92 standard sl?
Hydraulic clutch on that model is not ajustable. You either have a bad clutch slave cylinder, Or the clutch and pressure plate needs replaced.
When do you bleed your clutch?
after the clutch master cylinder has been replaced.
Should you replace your clutch master cylinder when replacing clutch?
At least the slave cylinder. The clutch master cylinder can be replaced at any time.
How can you fix the clutch in a 1992 GMC Sierra?
Clutch repair for a 1992 Sierra will depend on the problem. Clutch systems consist of the clutch, pressure plate and a master and slave cylinder. These parts are not repairable, and the part that has failed will have to be replaced.
Is your clutch going bad in your 1995 Toyota Paseo I have replaced master clutch cylinder and slave cylinder?
Does my 1995 Toyota Paseo have a clutch cable
How do you know if your hydraulic clutch on your 1996 Sunfire is going out.?
If you clutch and it either goes all the way in with no pressure there is a leak in your slave cylinder or the higher you have to clutch means your clutch is sliping and has to be replaced. If your doing a lot of power shifting i would suggest you get a racing clutch instead.
How do you know when the clutch master cylinder is gone in a 1995 escort?
Whenever you are having a problem with the clutch disengaging the engine from the transmission it is advisable to bleed the clutch slave cylinder. If the clutch can't be operated by bleeding the slave cylinder then the clutch master cylinder is gone and should be replaced.
I replaced a 1991 Nissan 204sx slave cylinder. Now it will not build up pressure and the pedal stays to the floor. What is the problem?
You need to bleed the clutch
Where does the little rod go in a 1990 Mitsubishi pickup just replaced the clutch and forgot the rod?
If you just replaced the clutch and pressure plate, the only "little rod" I can think of is in the slave cylinder. It is what pushes the fork in to disengage the clutch. If you did not put it in, you should not be able to shift or engage the clutch. The slave cylinder should blow out the seal when you step on the clutch pedal. The rod is about the diameter of a pencil and 2 inches long more or less?
Just replaced a tranny. Is it normal for the shift lever to be able to shift into all gears without the clutch being depressed. Something to do with the clutch slave cylinder pressure from bleeding?
Theres no pressure in the transmission yet. Once you start the engine it will be normal
How do you adjust the clutch on 1991 Chevrolet 2500?
It is notadjustable, You either have a bad clutch slave cylinder, clutch master cylinder. The clutch and pressure plate may just be worn out.
Can you adjust a clutch pedal on a Chevy 2001 blazer?
No.... There is not an adjustment what so ever. You either have a bad clutch slave cylinder / clutch master cylinder. Are the clutch and pressure plate are worn out.
