This might not be the best answer to your question, but I'll tell you what I did when my 86 bronco was making me nuts with the same problem. I traced the fuel pump wire from the tank to the engine compartment and cut it by where the wire turns from two wires to one and hot wired it to an ignition wire that is only on when the key is turned on, after that mine never stalled again, but you do have to be careful because every time the key is on the fuel pumps will be running, or just change the computer as I believe that is where the problem really lies
We replaced the temperature gauge in my 1991 Chevy blazer what is the normal operating temp?
They are not designed to work at normal operating temperature They are designed to work when A/C or defroster is on and/or engine coolant temperature exceeds 235 degrees
I would guess that the thermostat is not opening at the proper temperature. Once it does open proper circulation brings it down to the correct operating temperature. I think it should be replaced.
the ignition timing does not get replaced on 87 dodge.
The ignition is shot - just replaced mine $315.00.
A refurbished oven has all its working parts replaced (burner, ignition, temperature sensor). A new oven has never been used or installed.
This could be a bad ignition switch, ignition relay, or ignition fuse.
did you have your ignition coil replaced? the signs are that the ignition coil is overheating thus you are able to restart after an hour, when the coil cools. also check if your ignition coil has a resistor. if it has, have it checked for continuity. did you have your ignition coil replaced? the signs are that the ignition coil is overheating thus you are able to restart after an hour, when the coil cools. also check if your ignition coil has a resistor. if it has, have it checked for continuity.
check the ignition switch , it might be bad and may need to be replaced.
you can take it to be replaced it has a recall on them
tumbler has slipped. hit key with mallet . but ignition keylock will soon have to be replaced
I'd call a locksmith. The ignition wil probably have to be drilled and replaced.