Stop driving this car immediately. Take it to a professional. You have an intake plenum that is possibly leaking or is cracked. Severe engine damage can occur if you continue to drive this car. Coolant can enter the combustion chamber which will destroy this engine.
under the throtle body follow the big coolant hose that comes out from the upper part of the radiator tho the engine ull see a sensor screw in to the thermostat housing with two wires to it
underneath the throtle body, its just a wired plug screwed in just below the intake inlet. if that makes any sence
Driver side of the throtle body.Driver side of the throtle body.
inlet air temp should be between the throtle and air filter box on the air intake hose coolant temp should be close to were the upper radiator hose connects to engine there maybe 2 coolant sensors one for computer one for radiator cooling .
no they dont they have a throtle body injection(TBI) no they dont they have a throtle body injection(TBI)
The coolant temperature sensor is located below the Throtle Position senson, just to the right of the thermostat housing. If you are standing on the drivers side you would look down on the side facing (look close) you. It is a little black ob-round plug that goes into the side of the motor.
Probably idle control sosonoid located on the throtle body. Take it off and clean it and where it mounts. Also cleqan the inside of the throtle body where the throtle plate is as a carrbon ring forms there.
Plugged fuel filter.
It is located in the valley between the cylinders. You can loosen the throtle body, all the bolts holding the intake manifold and then lift the manifols just enough without disturbing the fuel rail to gain access from the lest side of the car to the right. This can be done with common tools and the gaskets on the manifold and TB can be reused if not damaged.
Hey Howard==It probably is the idle speed solonoid. Take if off of the throtle body and clean it with carb cleaner. Also clean the inside of the throtle body where the throtle plate is as a carbon ring forms around there. GoodluckJoe
It is controlled by the computer and is not adjustable. If it is so slow that the engine wom't idle the idle control solonoid needs cleaning. It is attached tothe throtle body and clean it and where it mounts with carb cleaner. Also clean the inside of the throtle body where the throtle plate is as a carbon ring forms there.
It is in the ducting before the throtle body.