Check fuses in power distribution block under hood
bad ground in high beam switch
Orange
If the high beam switch is broken that it should be replaced. When the unit is replaced the high beams will work again.
i have a 96 olds achieva and my high beam light was flashing, i checked the headlights and one of my low beam headlights was out. once replaced the flashing stopped.
Red with a black stripe.
you will probably have to replace the headlight switch.
No the high beam filament is independent from the low beam filament You can run them seperately or together . it depends on how the lights are set up. For instance if you have your high beam on you may have your lows running at the same time, however if your low beam is on low beam setting, your highs are always turned of It sounds like you may need to look at your fuses or your switch.
Low beams are burned out.
There are two different bulbd, 1 for dipped beam and 1 for full beam.
well a low beam can be from nothing to 1 foot high a medium beam is 2 and a half feet high and a standard high beam is 3 and a half feet high
Try the light switch
The low beam and the high beam may be two separate lights. The low beam and high beams are two separate bulbs. The lows are bulb # 9006 and the highs are bulb # 9005. If you only replaced one the other could be blown. If that isn't the problem then the switch on the steering column could be bad or so could the wiring but it is most likely the bulb.